Flywheel Housing
Show/hide table
Illustration 1 | g01240046 |
Typical example |
(1) Bolt
- M10 "8.8" ...
44 N·m (33 lb ft) - M10 "10.9" ...
63 N·m (47 lb ft) - M12 "8.8" ...
75 N·m (55 lb ft) - M12 "10.9" ...
115 N·m (85 lb ft) - M10 "10.9" ...
Tighten the bolts for the flywheel housing to the following torque:
Caterpillar Information System:
C3.3 Industrial Engine Engine Lifting Bracket
C3.3 Industrial Engine Crankshaft Pulley
3512B Oil Well Servicing Engine (ADEM III) Air Shutoff System
Reuse Specifications for 3600 Combustion Gaskets {0762, 0763, 1100, 1124, 1201} Reuse Specifications for 3600 Combustion Gaskets {0762, 0763, 1100, 1124, 1201}
C9 Generator Set Engine Muffler - Remove and Install
C7 On-highway Engine Engine Oil Pan
C9 Generator Set Engine Engine Enclosure Group - Install
C6.6 Engines for Caterpillar Built Machines Gear Group (Front)
C3.3 Industrial Engine Crankshaft Seals
C175 Generator Set Engines Connecting Rod Bearings - Remove and Install
2005/12/19 The New Low Gas Pressure Module is Now Available {1901}
2008/07/07 Coolant Sensor Installation Service Notes {5574}
C3.3 Industrial Engine Flywheel
C3.3 Industrial Engine Piston Cooling Jet
C3.3 Industrial Engine Piston and Rings
C3.3 Industrial Engine Connecting Rod - For Use With Steel Crankshaft
C3.3 Industrial Engine Main Bearing Journal - Steel Crankshaft
C3.3 Industrial Engine Connecting Rod Bearing Journal - Steel Crankshaft
C9 Generator Set Engine Cooling System Package (Radiator, Aftercooler, Fuel Cooler) - Remove
EMCP3 Engine Setpoint Verification - Test
C7 Marine Engine Alternator and Regulator
C7 Marine Engine Alternator and Regulator
C9 Generator Set Engine Cooling System Package (Radiator, Aftercooler, Fuel Cooler) - Install
C11 and C13 Engines Water Pump