Flywheel
Show/hide table
Illustration 1 | g00584712 |
Standard flywheel |
(1) Flywheel ring gear
- Heat the flywheel ring gear to the following temperature. ...
250 °C (480 °F)
Note: Do not use an oxyacetylene torch to heat the flywheel ring gear.
(2) Flywheel
(3) Bolt
- Tighten the flywheel bolts to the following torque. ...
140 N·m (103 lb ft)
Note: A special flywheel is aligned to a dowel on the crankshaft.
Caterpillar Information System:
C3.3 Industrial Engine Flywheel Housing
C3.3 Industrial Engine Engine Lifting Bracket
C3.3 Industrial Engine Crankshaft Pulley
3512B Oil Well Servicing Engine (ADEM III) Air Shutoff System
Reuse Specifications for 3600 Combustion Gaskets {0762, 0763, 1100, 1124, 1201} Reuse Specifications for 3600 Combustion Gaskets {0762, 0763, 1100, 1124, 1201}
C9 Generator Set Engine Muffler - Remove and Install
C7 On-highway Engine Engine Oil Pan
C9 Generator Set Engine Engine Enclosure Group - Install
C6.6 Engines for Caterpillar Built Machines Gear Group (Front)
C3.3 Industrial Engine Crankshaft Seals
C175 Generator Set Engines Connecting Rod Bearings - Remove and Install
2005/12/19 The New Low Gas Pressure Module is Now Available {1901}
C3.3 Industrial Engine Piston Cooling Jet
C3.3 Industrial Engine Piston and Rings
C3.3 Industrial Engine Connecting Rod - For Use With Steel Crankshaft
C3.3 Industrial Engine Main Bearing Journal - Steel Crankshaft
C3.3 Industrial Engine Connecting Rod Bearing Journal - Steel Crankshaft
C9 Generator Set Engine Cooling System Package (Radiator, Aftercooler, Fuel Cooler) - Remove
EMCP3 Engine Setpoint Verification - Test
C7 Marine Engine Alternator and Regulator
C7 Marine Engine Alternator and Regulator
C9 Generator Set Engine Cooling System Package (Radiator, Aftercooler, Fuel Cooler) - Install
C11 and C13 Engines Water Pump
320D and 323D Excavators Machine System Specifications Solenoid Valve (Quick Coupler)