Control Valve (Counterweight Circuit) - Install
安装步骤
Show/hide table
| 所需工具 | |||
|---|---|---|---|
| 工具 | 零件号 | 零件说明 | 数量 |
| A | FT-2674 | 真空舱 | 1 |
- 在机器上将配重控制阀 (4) 放置到位。 安装螺栓 (3) 。
Show/hide table
 | |
| 图 1 | g00636130 |
- 将软管组件 (2) 连接到配重控制阀。
- 安装销 (1) 、垫圈和开口销。
Show/hide table
 | |
| 图 2 | g00636151 |
- 拆下工具 (A) 。
Show/hide table
 | |
| 图 3 | g01196137 |
- 加注液压油箱至正确油位。 请参阅操作和保养手册, "液压系统油位 – 检查"。
Caterpillar Information System:
TH31 Well Servicing Transmissions Modulating Valve (Torque Converter Lockup Clutch) - Remove and Install
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Swing Gear and Bearing - Install
C11 and C13 Engines Water Pump
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Swing Gear and Bearing - Remove
TH31 Well Servicing Transmissions Modulating Valve (Transmission Clutch) - Remove and Install
TH48-E80 Petroleum Transmission General Information
C175 Generator Set Engines Electronic Control Module (Engine) - Remove and Install
C175 Generator Set Engines Water Temperature Control Valve - Install
C7 Engines for Caterpillar Built Machines Flywheel
TH31-C9I, TH31-C9P, TH31-C9T, TH35-C13I, TH35-C13T, TH35-C15I and TH35-C15T Petroleum Power Train Packages and TH31-E61 and TH35-E81 Petroleum Transmissions Transmission Oil Filter (Transmission)
C15 and C18 Engines for Caterpillar Built Machines Piston Cooling Jet
C7 Petroleum Engines Water Lines
Removal and Installation of the 126-1774 Endbell Cover {7553} Removal and Installation of the 126-1774 Endbell Cover {7553}
3500 Engines Turbocharger
C27 and C32 Generator Set Engines Can Not Reach Top Engine RPM
C27 and C32 Generator Set Engines Engine Will Not Crank
C27 and C32 Generator Set Engines Intermittent Low Power or Power Cutout
C27 and C32 Generator Set Engines Low Power/Poor or No Response to Throttle
C27 and C32 Generator Set Engines Event Codes
3176C, 3196 and 3406E Engines for 725, 730, 735, 740, and 740 Ejector Articulated Trucks CID 0001 FMI 11 Cylinder #1 Injector fault
3176C, 3196 and 3406E Engines for 725, 730, 735, 740, and 740 Ejector Articulated Trucks CID 0002 FMI 11 Cylinder #2 Injector fault
3176C, 3196 and 3406E Engines for 725, 730, 735, 740, and 740 Ejector Articulated Trucks CID 0003 FMI 11 Cylinder #3 Injector fault
TH31 Well Servicing Transmissions Speed Sensor (Transmission) - Remove and Install
3176C, 3196 and 3406E Engines for 725, 730, 735, 740, and 740 Ejector Articulated Trucks CID 0004 FMI 11 Cylinder #4 Injector fault