3176C, 3196 and 3406E Engines for 725, 730, 735, 740, and 740 Ejector Articulated Trucks Caterpillar


CID 0003 FMI 11 Cylinder #3 Injector fault

Usage:

3176C 3PD
Conditions Which Generate This Code:

The Electronic Control Module (ECM) is attempting to operate the injector. The ECM detects an open or a short in the circuit for the injector.

System Response:

The ECM will log the diagnostic code. The ECM will continue to attempt to operate the injector after the code has been logged.

The injector may not operate while the condition exists.

  • Engine misfires

  • Low power

Test Step 1. Perform the following diagnostic procedure: Injector Solenoid Circuit - Test

Results:

  • OK - STOP

Caterpillar Information System:

3176C, 3196 and 3406E Engines for 725, 730, 735, 740, and 740 Ejector Articulated Trucks CID 0002 FMI 11 Cylinder #2 Injector fault
3176C, 3196 and 3406E Engines for 725, 730, 735, 740, and 740 Ejector Articulated Trucks CID 0001 FMI 11 Cylinder #1 Injector fault
C27 and C32 Generator Set Engines Event Codes
C27 and C32 Generator Set Engines Low Power/Poor or No Response to Throttle
C27 and C32 Generator Set Engines Intermittent Low Power or Power Cutout
C27 and C32 Generator Set Engines Engine Will Not Crank
C27 and C32 Generator Set Engines Can Not Reach Top Engine RPM
3500 Engines Turbocharger
Removal and Installation of the 126-1774 Endbell Cover {7553} Removal and Installation of the 126-1774 Endbell Cover {7553}
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Control Valve (Counterweight Circuit) - Install
TH31 Well Servicing Transmissions Modulating Valve (Torque Converter Lockup Clutch) - Remove and Install
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Swing Gear and Bearing - Install
TH31 Well Servicing Transmissions Speed Sensor (Transmission) - Remove and Install
3176C, 3196 and 3406E Engines for 725, 730, 735, 740, and 740 Ejector Articulated Trucks CID 0004 FMI 11 Cylinder #4 Injector fault
3176C, 3196 and 3406E Engines for 725, 730, 735, 740, and 740 Ejector Articulated Trucks CID 0005 FMI 11 Cylinder #5 Injector fault
3176C, 3196 and 3406E Engines for 725, 730, 735, 740, and 740 Ejector Articulated Trucks CID 0006 FMI 11 Cylinder #6 Injector fault
C175 Generator Sets Product Storage
3500 Engines Turbocharger
C13 On-highway Engine Fuel Transfer Pump
TH31-C9I, TH31-C9P, TH31-C9T, TH35-C13I, TH35-C13T, TH35-C15I and TH35-C15T Petroleum Power Train Packages and TH31-E61 and TH35-E81 Petroleum Transmissions Transmission Transmission Mounting - TH31 Transmission Support
C32 Petroleum Engines Air Shutoff - Remove
C32 Petroleum Engines Air Shutoff - Install
C15 and C18 Engines for Caterpillar Built Machines Belt Tensioner
C32 Petroleum Engines Air Shutoff - Disassemble
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.