Water Pump
Show/hide table
 | |
| 图 1 | g01419643 |
(1) 水泵轴 (2) 轮毂 | |
(A) 叶轮和壳体的间隙 ... 0.75 ± 0.25 mm (0.030 ± 0.010 in)
(B) 已安装密封的高度 ... 12.19 ± 0.13 mm (0.480 ± 0.005 in)
(C) 轮毂前表面到壳体表面的距离 ... 151.80 ± 0.30 mm (5.976 ± 0.012 in)
注: 有关轴和密封安装的完整步骤请参阅拆解和组装。
Caterpillar Information System:
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Swing Gear and Bearing - Remove
TH31 Well Servicing Transmissions Modulating Valve (Transmission Clutch) - Remove and Install
TH48-E80 Petroleum Transmission General Information
C175 Generator Set Engines Electronic Control Module (Engine) - Remove and Install
C175 Generator Set Engines Water Temperature Control Valve - Install
C7 Engines for Caterpillar Built Machines Flywheel
TH31-C9I, TH31-C9P, TH31-C9T, TH35-C13I, TH35-C13T, TH35-C15I and TH35-C15T Petroleum Power Train Packages and TH31-E61 and TH35-E81 Petroleum Transmissions Transmission Oil Filter (Transmission)
C15 and C18 Engines for Caterpillar Built Machines Piston Cooling Jet
C7 Petroleum Engines Water Lines
CX31 On-Highway Transmission Modulating Valve
C7 Petroleum Engines Engine Oil Lines
TH31 Well Servicing Transmissions Bypass Valve - Remove and Install
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Swing Gear and Bearing - Install
TH31 Well Servicing Transmissions Modulating Valve (Torque Converter Lockup Clutch) - Remove and Install
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Control Valve (Counterweight Circuit) - Install
Removal and Installation of the 126-1774 Endbell Cover {7553} Removal and Installation of the 126-1774 Endbell Cover {7553}
3500 Engines Turbocharger
C27 and C32 Generator Set Engines Can Not Reach Top Engine RPM
C27 and C32 Generator Set Engines Engine Will Not Crank
C27 and C32 Generator Set Engines Intermittent Low Power or Power Cutout
C27 and C32 Generator Set Engines Low Power/Poor or No Response to Throttle
C27 and C32 Generator Set Engines Event Codes
3176C, 3196 and 3406E Engines for 725, 730, 735, 740, and 740 Ejector Articulated Trucks CID 0001 FMI 11 Cylinder #1 Injector fault
3176C, 3196 and 3406E Engines for 725, 730, 735, 740, and 740 Ejector Articulated Trucks CID 0002 FMI 11 Cylinder #2 Injector fault