Hydraulic Track Adjusters - Disassemble
Disassembly Procedure
Start By:
- Remove the hydraulic track adjusters. Refer to Disassembly and Assembly, "Hydraulic Track Adjusters - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Check the condition of all seals and of all components. If any parts are worn or damaged, use new parts for replacement.
- Remove seal (1) that is in ring (2) .
Show/hide table
Illustration 1 | g00399518 |
- Remove ring (2) .
- Remove piston (3) and the washer.
- Remove valve (4) and the washer.
- Remove relief valve (5) .
- Remove the ring that holds seal (6) in position. Remove seal (6) .
Show/hide table
Illustration 2 | g00399519 |
- Remove two rings (7) .
Caterpillar Information System:
854G Wheel Dozer Machine Systems Front Frame and Rear Frame - Connect
854G Wheel Dozer Machine Systems Front Frame and Rear Frame - Separate
613C Series II Wheel Tractor-Scraper Machine Systems Parking Brake Actuator - Disassemble
966G Wheel Loader and 972G Wheel Loader Machine Systems Lift Arms - Install
613C Series II Wheel Tractor-Scraper Machine Systems Parking Brake Actuator - Install
613C Series II Wheel Tractor-Scraper Machine Systems Check Valve (Floor) - Remove
3306B Industrial Engine Electric Starting Motor
613C Series II Wheel Tractor-Scraper Machine Systems Floor Roller - Assemble
G3304 and G3306 Engines Electric Starting Motor
D6G Track-Type Tractor Power Train Hydraulic Track Adjusters - Install
966G Wheel Loader and 972G Wheel Loader Machine Systems Lift Arms - Remove
994D Wheel Loader Braking System Brake Valve (Service Brake)
Field Installation of Decelerator Pedal{1276} Field Installation of Decelerator Pedal{1276}
D6G Track-Type Tractor Power Train Hydraulic Track Adjusters - Assemble
D6G Track-Type Tractor Power Train Recoil Spring - Remove and Install
994D Wheel Loader Power Train Speed Sensor (Torque Converter Output)
613C Series II Wheel Tractor-Scraper Machine Systems Parking Brake Actuator - Assemble
D6G Track-Type Tractor Power Train Recoil Spring - Disassemble
953C, 963C and 973C Track-Type Loaders Transmission Electronic Control System Electronic Control Module (ECM) - Replace
994D Wheel Loader Power Train Modulating Valve (Torque Converter Impeller Clutch)
613C Series II Wheel Tractor-Scraper Machine Systems Parking Brake - Remove
613C Series II Wheel Tractor-Scraper Machine Systems Parking Brake - Install
627F Wheel Tractor-Scraper Cooling System Coolant (ELC) - Change
854G Wheel Dozer Machine Systems Gear Pump (Implement Pilot) - Remove