Camshaft - Remove
Removal Procedure
Start By:
- Remove the vibration damper. Refer to Disassembly and Assembly, "Vibration Damper and Pulley - Remove and Install".
- Remove the front cover. Refer to Disassembly and Assembly, "Front Cover - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Turn the crankshaft to top center compression stroke for the No. 1 piston. Refer to Testing and Adjusting, "Finding Top Center Position for No. 1 Piston".
- Ensure that the timing marks on the following gears are aligned: the camshaft drive gear, the idler gear and the crankshaft gear.
- Wire the valve lifters away from the camshaft.
- Remove bolts (3) and thrust plate (2) from camshaft gear (1) .
Show/hide table
Illustration 1 | g01088736 |
- Remove the camshaft.
Caterpillar Information System:
C7 Marine Engines Lifter Group - Remove and Install
3406E and 3456 Generator Set Engines E059 Low Engine Coolant Level Warning
C15 On-highway Engines Water Temperature Regulator Housing - Remove and Install
C7 Marine Engines Cylinder Head - Install
C7 Marine Engines Cylinder Head - Remove
3406E and 3456 Generator Set Engines E058 Low Engine Coolant Level Shutdown
3406E and 3456 Generator Set Engines E056 High Fuel Temperature Warning
C32 Marine Engine Safety Messages
2004/07/01 Flash Files are Now Available in order to Address Engine Misfires and will Improve Engine Acceleration {7620}
3406E and 3456 Generator Set Engines E027 High Inlet Air Temperature Warning
C7 Marine Engines Valve Mechanism Cover Base - Remove and Install
C7 Marine Engines Valve Mechanism Cover - Remove and Install
C7 Marine Engines Camshaft - Install
C7 Marine Engines Camshaft Gear - Remove and Install
C7 Marine Engines Camshaft Bearings - Remove and Install
C7 Marine Engines Engine Oil Pan - Remove and Install
2004/12/27 Coolant/Battery Tester Group Quickly Tests Coolant and Battery Acid {0773, 0785}
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Engine Wiring Information
G3600 Engines Unburned Gas - Purge
C7 Marine Engines Piston Cooling Jets - Remove and Install
C18 Marine Generator Set Engines Replacing the ECM
C7 Marine Engines Pistons and Connecting Rods - Remove
C7 Marine Engines Pistons and Connecting Rods - Disassemble
3406E and 3456 Generator Set Engines CID 0248 FMI 09 CAT Data Link communications