Camshaft - Install
Installation Procedure
- Carefully install the camshaft.
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Ensure that the timing marks on the following gears are aligned: the camshaft drive gear, the idler gear and the crankshaft gear.
Show/hide table
| NOTICE |
|---|
When installing the camshaft, make sure the number one cylinder is at top center of the compression stroke with the timing bolt installed in the flywheel. The camshaft timing is very important. The timing mark on the camshaft drive gear must line up with the timing mark on the idler gear. Refer to the Specifications Manual for more information. |
- Install thrust plate (2) and bolts (3) on camshaft gear (1) .
Show/hide table
 | |
| Illustration 1 | g01088736 |
End By:
- Install the front cover. Refer to Disassembly and Assembly, "Front Cover - Install".
- Install the vibration damper. Refer to Disassembly and Assembly, "Vibration Damper and Pulley - Remove and Install".
Caterpillar Information System:
C7 Marine Engines Camshaft - Remove
C7 Marine Engines Lifter Group - Remove and Install
3406E and 3456 Generator Set Engines E059 Low Engine Coolant Level Warning
C15 On-highway Engines Water Temperature Regulator Housing - Remove and Install
C7 Marine Engines Cylinder Head - Install
C7 Marine Engines Cylinder Head - Remove
3406E and 3456 Generator Set Engines E058 Low Engine Coolant Level Shutdown
3406E and 3456 Generator Set Engines E056 High Fuel Temperature Warning
C32 Marine Engine Safety Messages
2004/07/01 Flash Files are Now Available in order to Address Engine Misfires and will Improve Engine Acceleration {7620}
3406E and 3456 Generator Set Engines E027 High Inlet Air Temperature Warning
C7 Marine Engines Valve Mechanism Cover Base - Remove and Install
C7 Marine Engines Camshaft Gear - Remove and Install
C7 Marine Engines Camshaft Bearings - Remove and Install
C7 Marine Engines Engine Oil Pan - Remove and Install
2004/12/27 Coolant/Battery Tester Group Quickly Tests Coolant and Battery Acid {0773, 0785}
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Engine Wiring Information
G3600 Engines Unburned Gas - Purge
C7 Marine Engines Piston Cooling Jets - Remove and Install
C18 Marine Generator Set Engines Replacing the ECM
C7 Marine Engines Pistons and Connecting Rods - Remove
C7 Marine Engines Pistons and Connecting Rods - Disassemble
3406E and 3456 Generator Set Engines CID 0248 FMI 09 CAT Data Link communications
3126B Petroleum Engine Engine Wiring Information