Camshaft Gear - Remove and Install
Removal Procedure
Start By:
- Remove the camshaft. Refer to Disassembly and Assembly, "Camshaft - Remove".
- Wrap the camshaft with a protective covering in order to prevent damage to the camshaft.
- Place the camshaft and camshaft gear (1) in a suitable press. Press the camshaft from camshaft gear (1) .
Show/hide table
Illustration 1 | g00611152 |
Show/hide table
NOTICE |
---|
Do not allow the camshaft to fall to the floor when pressing it from the drive gear. Also make sure that the camshaft lobes do not catch on the press plates. |
Installation Procedure
- Raise the temperature of the camshaft gear.
- Align the key in the camshaft with the groove (keyway) in the camshaft gear.
- Install the camshaft gear on the end of the camshaft.
End By: Install the camshaft. Refer to Disassembly and Assembly, "Camshaft - Install".
Caterpillar Information System:
C7 Marine Engines Camshaft - Install
C7 Marine Engines Camshaft - Remove
C7 Marine Engines Lifter Group - Remove and Install
3406E and 3456 Generator Set Engines E059 Low Engine Coolant Level Warning
C15 On-highway Engines Water Temperature Regulator Housing - Remove and Install
C7 Marine Engines Cylinder Head - Install
C7 Marine Engines Cylinder Head - Remove
3406E and 3456 Generator Set Engines E058 Low Engine Coolant Level Shutdown
3406E and 3456 Generator Set Engines E056 High Fuel Temperature Warning
C32 Marine Engine Safety Messages
2004/07/01 Flash Files are Now Available in order to Address Engine Misfires and will Improve Engine Acceleration {7620}
3406E and 3456 Generator Set Engines E027 High Inlet Air Temperature Warning
C7 Marine Engines Camshaft Bearings - Remove and Install
C7 Marine Engines Engine Oil Pan - Remove and Install
2004/12/27 Coolant/Battery Tester Group Quickly Tests Coolant and Battery Acid {0773, 0785}
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Engine Wiring Information
G3600 Engines Unburned Gas - Purge
C7 Marine Engines Piston Cooling Jets - Remove and Install
C18 Marine Generator Set Engines Replacing the ECM
C7 Marine Engines Pistons and Connecting Rods - Remove
C7 Marine Engines Pistons and Connecting Rods - Disassemble
3406E and 3456 Generator Set Engines CID 0248 FMI 09 CAT Data Link communications
3126B Petroleum Engine Engine Wiring Information
3126B Petroleum Engine Customer Passwords