Cylinder Head - Remove
Removal Procedure
Start By:
- Remove the aftercooler. Refer to Disassembly and Assembly, "Aftercooler - Remove".
- Remove the unit injectors. Refer to Disassembly and Assembly, "Unit Injector - Remove".
- Remove the exhaust manifold. Refer to Disassembly and Assembly, "Exhaust Manifold - Remove and Install".
- Remove the engine oil filter base. Refer to Disassembly and Assembly, "Engine Oil Filter Base - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Attach a suitable lifting device to the cylinder head.
- Disconnect harness assembly (3) .
Show/hide table
Illustration 1 | g01081011 |
- Remove bolts (1) and (2) that hold the cylinder head to the cylinder block. Carefully remove the cylinder head from the cylinder block. The weight of the cylinder head is approximately 85 kg (187 lb).
- Remove the cylinder head gasket.
Caterpillar Information System:
3406E and 3456 Generator Set Engines E058 Low Engine Coolant Level Shutdown
3406E and 3456 Generator Set Engines E056 High Fuel Temperature Warning
C32 Marine Engine Safety Messages
2004/07/01 Flash Files are Now Available in order to Address Engine Misfires and will Improve Engine Acceleration {7620}
3406E and 3456 Generator Set Engines E027 High Inlet Air Temperature Warning
C7 Marine Engines Valve Mechanism Cover Base - Remove and Install
C7 Marine Engines Valve Mechanism Cover - Remove and Install
C7 Marine Engines Camshaft Idler Gear - Remove and Install
3406E and 3456 Generator Set Engines CID 0342 FMI 08 Secondary Engine Speed signal abnormal
C7 Marine Engines Housing (Front) - Install
C7 Marine Engines Housing (Front) - Remove
C15 On-highway Engines Variable Valve Actuator Oil Pressure Solenoid - Remove and Install
C7 Marine Engines Cylinder Head - Install
C15 On-highway Engines Water Temperature Regulator Housing - Remove and Install
3406E and 3456 Generator Set Engines E059 Low Engine Coolant Level Warning
C7 Marine Engines Lifter Group - Remove and Install
C7 Marine Engines Camshaft - Remove
C7 Marine Engines Camshaft - Install
C7 Marine Engines Camshaft Gear - Remove and Install
C7 Marine Engines Camshaft Bearings - Remove and Install
C7 Marine Engines Engine Oil Pan - Remove and Install
2004/12/27 Coolant/Battery Tester Group Quickly Tests Coolant and Battery Acid {0773, 0785}
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Engine Wiring Information
G3600 Engines Unburned Gas - Purge