Housing (Front) - Install
Installation Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 8T-9011     | Component Cleaner     | 1     |
B     | 4C-9500     | Quick Cure Primer     | 1     |
C     | 1U-8846     | Gasket Sealant     | 1     |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Clean the joint face on front housing (2) with Tooling (A) .
Show/hide table
Illustration 1 | g01238413 |
- Apply Tooling (B) to the joint face. Allow the primer to dry for at least three to five minutes.
- Apply Tooling (C) to the joint face. Spread the sealant uniformly. Front housing (2) must be installed within ten minutes of applying the sealant.
Note: Do not allow Tooling (C) to seal the main oil passage on front housing (2) .
- Position front housing (2) on the cylinder block and install bolts (1) and bolts (3) .
End By:
- Install the camshaft. Refer to Disassembly and Assembly, "Camshaft - Install".
- Install the vibration damper and the pulley. Refer to Disassembly and Assembly, "Vibration Damper and Pulley - Remove and Install".
- Install the auxiliary water pump. Refer to Disassembly and Assembly, "Auxiliary Water Pump - Install".
- Install the unit injector hydraulic pump. Refer to Disassembly and Assembly, "Unit Injector Hydraulic Pump - Install".
Caterpillar Information System:
C7 Marine Engines Housing (Front) - Remove
C15 On-highway Engines Variable Valve Actuator Oil Pressure Solenoid - Remove and Install
C7 Marine Engines Front Cover - Install
3406E and 3456 Generator Set Engines CID 0274 FMI 13 Atmospheric Pressure calibration required
3406E and 3456 Generator Set Engines CID 0274 FMI 04 Atmospheric Pressure short to ground
3406E and 3456 Generator Set Engines CID 0274 FMI 03 Atmospheric Pressure open/short to +batt
C7 Marine Engines Front Cover - Remove
3406E and 3456 Generator Set Engines CID 0273 FMI 13 Turbo Outlet Pressure calibration required
C7 Marine Engines Crankshaft Front Seal - Install
3406E and 3456 Generator Set Engines CID 0273 FMI 04 Turbo Outlet Pressure short to ground
C7 Marine Engines Crankshaft Front Seal - Remove
3406E and 3456 Generator Set Engines CID 0273 FMI 03 Turbo Outlet Pressure open/short to +batt
3406E and 3456 Generator Set Engines CID 0342 FMI 08 Secondary Engine Speed signal abnormal
C7 Marine Engines Camshaft Idler Gear - Remove and Install
C7 Marine Engines Valve Mechanism Cover - Remove and Install
C7 Marine Engines Valve Mechanism Cover Base - Remove and Install
3406E and 3456 Generator Set Engines E027 High Inlet Air Temperature Warning
2004/07/01 Flash Files are Now Available in order to Address Engine Misfires and will Improve Engine Acceleration {7620}
C32 Marine Engine Safety Messages
3406E and 3456 Generator Set Engines E056 High Fuel Temperature Warning
3406E and 3456 Generator Set Engines E058 Low Engine Coolant Level Shutdown
C7 Marine Engines Cylinder Head - Remove
C7 Marine Engines Cylinder Head - Install
C15 On-highway Engines Water Temperature Regulator Housing - Remove and Install