E056 High Fuel Temperature Warning
Conditions Which Generate This Code:
The Electronic Control Module (ECM) detects all of the following conditions:
- The fuel temperature is greater than
75 °C (167 °F) for at least 10 seconds. - The engine has been running at least 30 seconds. This 30 second delay begins once the engine speed is greater than zero rpm.
- 174-03 is not active.
- 174-04 is not active.
System Response:
The ECM will log the warning. The warning lamp will come on and the warning will be transmitted to the display. The ECM will reset the warning once the fuel temperature falls to
Troubleshooting:
Test Step 1. PERFORM A CHECK OF THE FUEL SYSTEM
- Perform a check of the fuel system. Refer to the appropriate topic in Testing and Adjusting for possible causes.
Expected Result:
There are no problems with the fuel system.
Results:
- OK - There may be an intermittent problem.
Repair: Monitor the operation of the engine.
Repair the problem.
Ensure that the repair eliminates the problem.
STOP
- Not OK - There is a problem with the fuel system.
Repair: Repair the problem.
Ensure that the repair eliminates the problem.
STOP
Caterpillar Information System:
C32 Marine Engine Safety Messages
2004/07/01 Flash Files are Now Available in order to Address Engine Misfires and will Improve Engine Acceleration {7620}
3406E and 3456 Generator Set Engines E027 High Inlet Air Temperature Warning
C7 Marine Engines Valve Mechanism Cover Base - Remove and Install
C7 Marine Engines Valve Mechanism Cover - Remove and Install
C7 Marine Engines Camshaft Idler Gear - Remove and Install
3406E and 3456 Generator Set Engines CID 0342 FMI 08 Secondary Engine Speed signal abnormal
C7 Marine Engines Housing (Front) - Install
C7 Marine Engines Housing (Front) - Remove
C15 On-highway Engines Variable Valve Actuator Oil Pressure Solenoid - Remove and Install
C7 Marine Engines Front Cover - Install
3406E and 3456 Generator Set Engines CID 0274 FMI 13 Atmospheric Pressure calibration required
3406E and 3456 Generator Set Engines E058 Low Engine Coolant Level Shutdown
C7 Marine Engines Cylinder Head - Remove
C7 Marine Engines Cylinder Head - Install
C15 On-highway Engines Water Temperature Regulator Housing - Remove and Install
3406E and 3456 Generator Set Engines E059 Low Engine Coolant Level Warning
C7 Marine Engines Lifter Group - Remove and Install
C7 Marine Engines Camshaft - Remove
C7 Marine Engines Camshaft - Install
C7 Marine Engines Camshaft Gear - Remove and Install
C7 Marine Engines Camshaft Bearings - Remove and Install
C7 Marine Engines Engine Oil Pan - Remove and Install
2004/12/27 Coolant/Battery Tester Group Quickly Tests Coolant and Battery Acid {0773, 0785}