Housing (Front) - Remove
Removal Procedure
Start By:
- Remove the unit injector hydraulic pump. Refer to Disassembly and Assembly, "Unit Injector Hydraulic Pump - Remove".
- Remove the auxiliary water pump. Refer to Disassembly and Assembly, "Auxiliary Water Pump - Remove".
- Remove the vibration damper and the pulley. Refer to Disassembly and Assembly, "Vibration Damper and Pulley- Remove and Install".
- Remove the camshaft. Refer to Disassembly and Assembly, "Camshaft - Remove".
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Remove bolts (1) and bolts (3) that fasten front housing (2) to the cylinder block and to the engine oil pan.
Show/hide table
 | |
| Illustration 1 | g01238413 |
- Remove front housing (2) . Clean the sealant from front housing (2) and the cylinder block.
Caterpillar Information System:
C15 On-highway Engines Variable Valve Actuator Oil Pressure Solenoid - Remove and Install
C7 Marine Engines Front Cover - Install
3406E and 3456 Generator Set Engines CID 0274 FMI 13 Atmospheric Pressure calibration required
3406E and 3456 Generator Set Engines CID 0274 FMI 04 Atmospheric Pressure short to ground
3406E and 3456 Generator Set Engines CID 0274 FMI 03 Atmospheric Pressure open/short to +batt
C7 Marine Engines Front Cover - Remove
3406E and 3456 Generator Set Engines CID 0273 FMI 13 Turbo Outlet Pressure calibration required
C7 Marine Engines Crankshaft Front Seal - Install
3406E and 3456 Generator Set Engines CID 0273 FMI 04 Turbo Outlet Pressure short to ground
C7 Marine Engines Crankshaft Front Seal - Remove
3406E and 3456 Generator Set Engines CID 0273 FMI 03 Turbo Outlet Pressure open/short to +batt
3406E and 3456 Generator Set Engines CID 0273 FMI 00 Turbo Outlet Pressure above normal
C7 Marine Engines Housing (Front) - Install
3406E and 3456 Generator Set Engines CID 0342 FMI 08 Secondary Engine Speed signal abnormal
C7 Marine Engines Camshaft Idler Gear - Remove and Install
C7 Marine Engines Valve Mechanism Cover - Remove and Install
C7 Marine Engines Valve Mechanism Cover Base - Remove and Install
3406E and 3456 Generator Set Engines E027 High Inlet Air Temperature Warning
2004/07/01 Flash Files are Now Available in order to Address Engine Misfires and will Improve Engine Acceleration {7620}
C32 Marine Engine Safety Messages
3406E and 3456 Generator Set Engines E056 High Fuel Temperature Warning
3406E and 3456 Generator Set Engines E058 Low Engine Coolant Level Shutdown
C7 Marine Engines Cylinder Head - Remove
C7 Marine Engines Cylinder Head - Install