Engine Oil Pump - Install
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 将发动机机油泵 (5) 安置在缸体中的定位销上。 安装螺栓 (4)。
注: 确保在拧紧螺栓前先使发动机机油泵在定位销上就座。
- 将 O 形密封圈安装在管组件 (7) 上。 使用清洁的发动机机油润滑发动机机油泵中的孔。 将管组件 (7) 安装到发动机机油泵中。 安装垫圈和螺栓 (6)。
- 安装螺栓 (3),将钟形吸油管组件 (8) 固定到盘 (9) 上。
- 将 O 形密封圈安装在管组件 (1) 上。 使用清洁的发动机机油润滑发动机机油泵中的孔。 将管组件 (1) 安装到发动机机油泵中。 安装螺栓 (2)。
Show/hide table
图 1 | g01048711 |
结束:
- 安装发动机油底壳。 请参阅拆解和组装, "发动机油底壳 - 拆卸和安装"。
Caterpillar Information System:
3524B Engines for 797 and 797B Off-Highway Trucks Cold Mode Operation
C15 and C18 Engines for Caterpillar Built Machines Engine Oil Pump - Remove
C9 Marine Auxiliary and Marine Generator Set Engines Speed Control (Switch) - Test
C15 and C18 Engines for Caterpillar Built Machines Turbocharger - Assemble
C15 and C18 Engines for Caterpillar Built Machines Turbocharger - Disassemble
C32 Marine Engine Plate Locations and Film Locations
C9 Marine Auxiliary and Marine Generator Set Engines Switch Circuits - Test
Bench Test Procedure for Hydraulic Piston Pumps {5070} Bench Test Procedure for Hydraulic Piston Pumps {5070}
C-15, C-16 and C-18 Truck Engines Pistons and Connecting Rods - Install
C15 and C18 Engines for Caterpillar Built Machines Turbocharger - Install
C15 and C18 Engines for Caterpillar Built Machines Turbocharger - Remove
C15 and C18 Generator Set Engines Inlet and Exhaust Valve Guides - Remove and Install
C15 On-Highway Engine Engine Oil Pump - Disassemble
C15 On-Highway Engine Engine Oil Pump - Assemble
2004/03/29 Special Instruction, REHS1037 , "Installation Instructions for the Electric Fuel Priming Pump on Caterpillar Equipment With the 24 Volt System" has been Revised {1258}
C9 Marine Auxiliary and Marine Generator Set Engines Air Inlet Heater Circuit - Test
2003/12/01 New Procedures Will Increase Power Module Reliability {7273}
C18 Marine Auxiliary Engines E096 High Fuel Pressure
C15 and C18 Generator Set Engines Inlet and Exhaust Valve Springs - Remove and Install
C15 Engine Cooling System Coolant (DEAC) - Change
C15 Engine Cooling System Coolant (ELC) - Change
C15 and C18 Generator Set Engines Inlet and Exhaust Valves - Remove and Install
G3500 Engines Detonation Sensors
C13, C15, and C18 Generator Set Engines E197 High Engine Oil Temperature