Cold Mode Operation
在冷起动模式期间,燃油喷射会受限制,并通过电子控制模块(ECM)进行燃油喷射正时调节。 冷起动模式可降低发动机损坏的可能性,并有助于最大程度地减少白烟。
在低温模式期间,将根据发动机冷却液温度进行正时。
当发动机冷却液温度低于
Caterpillar Information System:
C15 and C18 Engines for Caterpillar Built Machines Engine Oil Pump - Remove
C9 Marine Auxiliary and Marine Generator Set Engines Speed Control (Switch) - Test
C15 and C18 Engines for Caterpillar Built Machines Turbocharger - Assemble
C15 and C18 Engines for Caterpillar Built Machines Turbocharger - Disassemble
C32 Marine Engine Plate Locations and Film Locations
C9 Marine Auxiliary and Marine Generator Set Engines Switch Circuits - Test
Bench Test Procedure for Hydraulic Piston Pumps {5070} Bench Test Procedure for Hydraulic Piston Pumps {5070}
C-15, C-16 and C-18 Truck Engines Pistons and Connecting Rods - Install
C15 and C18 Engines for Caterpillar Built Machines Turbocharger - Install
C15 and C18 Engines for Caterpillar Built Machines Turbocharger - Remove
C15 and C18 Generator Set Engines Inlet and Exhaust Valve Guides - Remove and Install
C15 and C18 Generator Set Engines Inlet and Exhaust Valve Seat Inserts - Remove and Install
C15 and C18 Engines for Caterpillar Built Machines Engine Oil Pump - Install
C15 On-Highway Engine Engine Oil Pump - Disassemble
C15 On-Highway Engine Engine Oil Pump - Assemble
2004/03/29 Special Instruction, REHS1037 , "Installation Instructions for the Electric Fuel Priming Pump on Caterpillar Equipment With the 24 Volt System" has been Revised {1258}
C9 Marine Auxiliary and Marine Generator Set Engines Air Inlet Heater Circuit - Test
2003/12/01 New Procedures Will Increase Power Module Reliability {7273}
C18 Marine Auxiliary Engines E096 High Fuel Pressure
C15 and C18 Generator Set Engines Inlet and Exhaust Valve Springs - Remove and Install
C15 Engine Cooling System Coolant (DEAC) - Change
C15 Engine Cooling System Coolant (ELC) - Change
C15 and C18 Generator Set Engines Inlet and Exhaust Valves - Remove and Install
G3500 Engines Detonation Sensors