Fuel Injector - Install
安装步骤
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 用清洁的发动机机油润滑座圈 (6) 。 将新座圈 (6) 安装到缸盖中。
注: 如果继续使用原来的座圈 (6) ,喷油器 (1) 的突出量可能不正确。
Show/hide table
图 1 | g01129982 |
- 将一个新 O 形密封圈 (5) 安装到喷油器 (1) 上。 将喷油器 (1) 安装到缸盖中。
注: 定位销 (7) 必须在卡箍 (4) 对面。
- 将卡箍 (4) 放置在喷油器 (1) 上。 安装调整螺钉 (3) 。 拧紧调整螺钉至扭矩为 27 N·m (20 lb ft)。
- 将软管 (2) 安装至喷油器 (1) 。
End By:
- 安装喷油管。 请参阅本 解体和组装, "喷油管 - 安装"。
- 拆下喷油器罩。 请参阅本 解体和组装手册, "喷油器罩 - 拆卸和安装"。
Caterpillar Information System:
3406C Marine Auxiliary Generator Set Gauges and Indicators
G3500 Engines Duplex Oil Filter - Adjust
2003/08/01 New Fabricated Tool for Piston Pin Installation {1225}
C15 On-highway Engine Gear Group (Front) - Install
C15 On-highway Engine Gear Group (Front) - Remove
C3.4 IND Industrial Engine Fuel System Primary Filter/Water Separator - Drain
C3.4 IND Industrial Engine Fuel System - Prime
2003/07/14 Policy for Reusing the Turbocharger Turbine Housing {1065}
2003/07/01 Policy for Reusing the Turbocharger Turbine Housing {1052, 1065, 7754}
2003/07/01 Make Sure That the Shunt Tank's Filler Neck is Vented {1354, 1377}
2003/07/01 Align the Balancer Gears {1204, 1206, 1220}
2003/07/01 Improved Auxiliary Pumps are Used {1371}
C11, C13 and C15 On-highway Engines Engine/Gear Parameters
C11, C13 and C15 On-highway Engines Idle Parameters
C11, C13 and C15 On-highway Engines Engine Monitoring Parameters
C11, C13 and C15 On-highway Engines Dedicated PTO Parameters
C11, C13 and C15 On-highway Engines Vehicle Speed Parameters
C11, C13 and C15 On-highway Engines Input Selections
Cat® Digital Voltage Regulator Remote Communication
3508C, 3512C and 3516C Marine Engines Auxiliary Water Pump - Install
2003/07/01 Replacement of the ECM for Heavy-Duty On-Highway Engines {1901}
2003/10/01 Policy for Reusing the Turbocharger Turbine Housing {1052, 1065, 7754}
2003/07/01 Identifying the Prelube Circuit and the Air Start Circuit {1408}
120H and 135H Motor Graders Machine Systems Metering Pump (Steering) - Remove and Install