Fuel System - Prime
如果空气进入燃油系统,在发动机起动前,必须排除燃油系统的空气。 发生下列事件时,空气可能进入燃油系统。
- 燃油箱排空或燃油箱部分排放。
- 断开低压燃油管。
- 低压燃油系统存在泄漏。
- 更换过燃油滤清器时。
按照下列步骤,排出燃油系统中的空气:
- 打开通气螺钉 (1) 。 把钥匙开关转到 运转(RUN)位置,直到没有空气的燃油从接头流出。 把钥匙开关转到断开(OFF)位置。
Show/hide table
图 1 | g01372204 |
典型范例 |
- 拧紧通气螺钉至7 N·m (61 lb in)。
- 把钥匙开关转到运转(RUN)位置。 保持钥匙开关在运转(RUN)位置1分钟。
- 把钥匙开关转到断开(OFF)位置。
- 松开全部喷油器高压燃油管的锥螺母 (1) 。
注: 如果过度用起动马达来排除燃油系统的空气,可能损坏燃油喷油泵、蓄电池和起动马达。
Show/hide table
图 2 | g01354358 |
典型范例 |
- 操作起动马达并盘动发动机。 观察松动的接头。
Show/hide table
注意 |
---|
发动机盘车时间不要超过 10 秒钟。 再次盘车前,让起动马达冷却30秒钟。 当飞轮正在转动时,不要接合起动马达。 |
- 当没有空气的燃油流出接头时,拧紧接头。
- 拧紧油管螺母至扭矩为29 N·m (21 lb ft)。
- 发动机准备起动。 排除燃油系统的空气后,立即使发动机以低怠速最少运转五分钟。
注: 发动机这段时间的运转将保证泵中彻底无空气。
Caterpillar Information System:
2003/07/14 Policy for Reusing the Turbocharger Turbine Housing {1065}
2003/07/01 Policy for Reusing the Turbocharger Turbine Housing {1052, 1065, 7754}
2003/07/01 Make Sure That the Shunt Tank's Filler Neck is Vented {1354, 1377}
2003/07/01 Align the Balancer Gears {1204, 1206, 1220}
2003/07/01 Improved Auxiliary Pumps are Used {1371}
C15 On-highway Engine Flywheel Housing - Remove and Install
2012/10/26 Policy for the Reuse of the Turbocharger Turbine Housing {1065}
2003/08/01 An Improved Air Lines Group and Carburetor Groups Are Available {1071, 1266}
3456 Generator Sets Rotating Rectifier - Test
3114, 3116, and 3126 Engines for Caterpillar Built Machines Camshaft - Install
C15 On-highway Engine Air Lines
C15 On-highway Engine Turbocharger
C3.4 IND Industrial Engine Fuel System Primary Filter/Water Separator - Drain
C15 On-highway Engine Gear Group (Front) - Remove
C15 On-highway Engine Gear Group (Front) - Install
2003/08/01 New Fabricated Tool for Piston Pin Installation {1225}
G3500 Engines Duplex Oil Filter - Adjust
3406C Marine Auxiliary Generator Set Gauges and Indicators
C3.3 Industrial Engine Fuel Injector - Install
C11, C13 and C15 On-highway Engines Engine/Gear Parameters
C11, C13 and C15 On-highway Engines Idle Parameters
C11, C13 and C15 On-highway Engines Engine Monitoring Parameters
C11, C13 and C15 On-highway Engines Dedicated PTO Parameters
C11, C13 and C15 On-highway Engines Vehicle Speed Parameters