G3520C and G3520E Generator Set Engines Caterpillar


Rocker Shaft and Push Rod - Install

Usage:

G3520C B9P

安装步骤

表 1
所需工具    
工具     零件号     零件说明     数量    
A     8T-2998     润滑剂     -    



    图 1g01545374

  1. 安装气门桥 (5) 。



    图 2g01545376

  1. 在气门推杆 (4) 的两端涂抹工具 (A) 。 安装气门推杆 (4) 。

  1. 将轴组件 (2) 安置在底座组件 (3) 上。

    注: 将弹簧销放到正确位置。

  1. 安装螺栓 (1) 。 拧紧螺栓 (1) 至扭矩为 120 ± 20 N·m (89 ± 15 lb ft)。

  1. 固定气门间隙和气门桥。 请参阅测试和调整, "气门间隙和气门桥调整"。

End By: 安装气门室盖。 请参考 拆解和组装, "气门室罩盖- 拆卸和安装"。

Caterpillar Information System:

G3520C and G3520E Generator Set Engines Rocker Shaft and Push Rod - Remove
G3500B Engines Air Starting Motor - Turbine
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Coolant Level Sensor Circuit - Test
C15 On-highway Engine Variable Valve Actuator
C15 On-highway Engine Variable Valve Actuator Oil Pressure Sensor
EMCPII+ for Gas Engines Starting Motor Magnetic Switch - Test - for Engine with EIS
EMCPII+ for Gas Engines Starting Motor Magnetic Switch - Test - for Engine with ECM
3044C Industrial Engine and Engines for Caterpillar Built Machines Rocker Shaft
EMCPII+ for Gas Engines Electronic Ignition System
3044C Industrial Engine and Engines for Caterpillar Built Machines Fuel Injection Lines
3044C Industrial Engine and Engines for Caterpillar Built Machines General Information
EMCPII+ for Gas Engines Hourmeter Programming OP7
G3500B Engines Air Starting Motor
C3.3 Industrial Engine Reference Numbers
3044C Industrial Engine and Engines for Caterpillar Built Machines Valve Mechanism Cover
3044C Industrial Engine and Engines for Caterpillar Built Machines Cylinder Head
3044C Industrial Engine and Engines for Caterpillar Built Machines Fuel System
3046 Engine for Caterpillar Built Machines Air Inlet and Exhaust System
3044C Industrial Engine and Engines for Caterpillar Built Machines Lubrication System
3044C Industrial Engine and Engines for Caterpillar Built Machines Cooling System
3044C Industrial Engine and Engines for Caterpillar Built Machines Basic Engine
3044C Industrial Engine and Engines for Caterpillar Built Machines Electrical System
G3612 and G3616 Engines Cooling System Coolant Sample (Level 1) - Obtain
G3612 and G3616 Engines Cooling System Coolant Sample (Level 2) - Obtain
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.