Rocker Shaft
Show/hide table
| Required Tools | |||
|---|---|---|---|
| Tool | Part Number | Part Description | Qty |
| A | 8T-5096 | Dial Indicator Group | 1 |
| B | - | V Block | 2 |
Show/hide table
 | |
| Illustration 1 | g00984738 |
(1) Rocker shaft
- Diameter of the rocker shaft ... 18.980 to 19.000 mm (0.7472 to 0.7480 inch)
(2) Rocker arm
- Inside diameter of the rocker arm bushings ... 19.010 to 19.030 mm (0.7484 to 0.7492 inch)
- Clearance between the rocker arm bushing and the rocker shaft ... 0.010 to 0.050 mm (0.0004 to 0.0020 inch)
- Maximum permissible clearance between the rocker arm bushing and the rocker shaft ... 0.070 mm (0.0028 inch)
- Clearance between the rocker arm bushing and the rocker shaft ... 0.010 to 0.050 mm (0.0004 to 0.0020 inch)
(3) Spring
(4) Tighten the bolts evenly. Tighten the long bolt first. Tighten the bolts to the following torque. ... 10 to 20 N·m (7 to 15 lb ft)
Show/hide table
 | |
| Illustration 2 | g01256167 |
(5) Pushrods
Place the pushrod in Tooling (B). Use Tooling (A) in order to check all pushrods for runout. Replace the pushrod if the runout exceeds the following value. ... 0.30 mm (0.0118 inch)
Caterpillar Information System:
EMCPII+ for Gas Engines Electronic Ignition System
3044C Industrial Engine and Engines for Caterpillar Built Machines Fuel Injection Lines
3044C Industrial Engine and Engines for Caterpillar Built Machines General Information
EMCPII+ for Gas Engines Hourmeter Programming OP7
G3500B Engines Vibration Damper Guard
320B, 320B L and 320B N Excavators Cooling System Coolant Sample (Level 2) - Obtain
C11, C13 and C15 On-highway Engines Poor Acceleration or Response
C11, C13 and C15 On-highway Engines Low Power/Poor or No Response to Throttle
C11, C13 and C15 On-highway Engines Intermittent Low Power or Power Cutout
C7 and C9 On-Highway Engines Engine Cranks but Will Not Start
3406E, C-10 and C-12 On-highway Engines Driver Questionnaire Response
C11, C13 and C15 On-highway Engines Engine Misfires, Runs Rough or Is Unstable
EMCPII+ for Gas Engines Starting Motor Magnetic Switch - Test - for Engine with ECM
EMCPII+ for Gas Engines Starting Motor Magnetic Switch - Test - for Engine with EIS
C15 On-highway Engine Variable Valve Actuator Oil Pressure Sensor
C15 On-highway Engine Variable Valve Actuator
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Coolant Level Sensor Circuit - Test
G3500B Engines Air Starting Motor - Turbine
G3520C and G3520E Generator Set Engines Rocker Shaft and Push Rod - Remove
G3520C and G3520E Generator Set Engines Rocker Shaft and Push Rod - Install
G3500B Engines Air Starting Motor
C3.3 Industrial Engine Reference Numbers
3044C Industrial Engine and Engines for Caterpillar Built Machines Valve Mechanism Cover
3044C Industrial Engine and Engines for Caterpillar Built Machines Cylinder Head