Fuel Injection Lines
Show/hide table
 | |
| Illustration 1 | g00993243 |
(1) Tighten the nuts for the fuel injection lines to the following torque. ... 27 to 32 N·m (20 to 24 lb ft)
Caterpillar Information System:
3044C Industrial Engine and Engines for Caterpillar Built Machines General Information
EMCPII+ for Gas Engines Hourmeter Programming OP7
G3500B Engines Vibration Damper Guard
320B, 320B L and 320B N Excavators Cooling System Coolant Sample (Level 2) - Obtain
C11, C13 and C15 On-highway Engines Poor Acceleration or Response
C11, C13 and C15 On-highway Engines Low Power/Poor or No Response to Throttle
C11, C13 and C15 On-highway Engines Intermittent Low Power or Power Cutout
C7 and C9 On-Highway Engines Engine Cranks but Will Not Start
3406E, C-10 and C-12 On-highway Engines Driver Questionnaire Response
C11, C13 and C15 On-highway Engines Engine Misfires, Runs Rough or Is Unstable
3126B and 3126E On-highway Engines ECM Will Not Accept Factory Passwords
3126B and 3126E On-highway Engines Can Not Reach Vehicle Speed Limit
EMCPII+ for Gas Engines Electronic Ignition System
3044C Industrial Engine and Engines for Caterpillar Built Machines Rocker Shaft
EMCPII+ for Gas Engines Starting Motor Magnetic Switch - Test - for Engine with ECM
EMCPII+ for Gas Engines Starting Motor Magnetic Switch - Test - for Engine with EIS
C15 On-highway Engine Variable Valve Actuator Oil Pressure Sensor
C15 On-highway Engine Variable Valve Actuator
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Coolant Level Sensor Circuit - Test
G3500B Engines Air Starting Motor - Turbine
G3520C and G3520E Generator Set Engines Rocker Shaft and Push Rod - Remove
G3520C and G3520E Generator Set Engines Rocker Shaft and Push Rod - Install
G3500B Engines Air Starting Motor
C3.3 Industrial Engine Reference Numbers