Cover Group (Front Housing)
Show/hide table
Illustration 1 | g00936227 |
(1) Stud
-
Apply 154-9731 Thread Lock Compound to the stud's threads. (A) Distance from the face of the front housing to the end of the stud ... 73.2 ± 0.5 mm (2.88 ± 0.02 inch)
(2) Stud
- Torque ... 27 ± 4 N·m (20 ± 3 lb ft)
(3) Stud
Apply 154-9731 Thread Lock Compound to the stud's threads.
(4) Stud (three places)
- Torque ... 27 ± 4 N·m (20 ± 3 lb ft)
Caterpillar Information System:
G3406 and G3412 Generator Set Engines Cover Group (Rear Housing)
2002/11/01 A New Special Instruction Provides Information About The Protection Of The Oil System During Major Repair {1000, 1300, 7581}
C11 and C13 On-Highway Engines Rocker Shaft
C11 and C13 On-Highway Engines Lifter Group
3056E Industrial Engine Inlet Manifold - Install
3056E Industrial Engine Inlet Manifold - Remove
3056E Industrial Engine Inlet Air Temperature Sensor - Remove and Install
SR4 HV and SR4B HV Generators Generator Start-up Checklist
G3406 Engines Cylinder Head Valves
C11 and C13 On-Highway Engines Electronic Unit Injector
3056E Industrial Engine Boost Pressure Sensor - Remove and Install
C11 and C13 On-Highway Engines Engine Design
G3408 and G3412 Engines Cover Group (Rear Housing)
2002/11/11 Change in Torque for Camshaft Gear Bolt {1210, 1212}
2002/11/01 Change in Torque for Camshaft Gear Bolt {1210, 1212}
G3408 and G3412 Engines Cylinder Head Valves
3056E Industrial Engine Inlet and Exhaust Valves - Remove and Install
C18 Generator set and C18 Marine Engines Engine Oil Filter Base - Disassemble
C18 Generator set and C18 Marine Engines Engine Oil Filter Base - Assemble
G3406 Engines Crankshaft
2003/02/01 A New Overhaul Protection Group Is Available For The Overhaul Of A Cylinder {1000, 7950, 795C}
C7 Petroleum Engines Electronic Control System Components
C7 and C9 On-Highway Engines Customer Specified Parameters
G3408 and G3412 Engines Carburetor Control Linkage