Carburetor Control Linkage
Show/hide table
Illustration 1 | g02178673 |
(A) Angle of the throttle lever at the minimum fuel position ... 40 degrees
(B) Angle of the throttle lever at the maximum fuel position ... 35 degrees
(1) Torque for two taperlock studs ... 17 ± 5 N·m (150 ± 44 lb in)
(2) Torque for two jam nuts ... 13 ± 3 N·m (115 ± 27 lb in)
(C) Travel of the actuator lever ... 37.7 degrees
(D) Travel of the actuator shaft ... 12 degrees
(E) Distance from center to center of the rod ends ... 481 mm (18.9 inch)
Caterpillar Information System:
C7 and C9 On-Highway Engines Customer Specified Parameters
C7 Petroleum Engines Electronic Control System Components
2003/02/01 A New Overhaul Protection Group Is Available For The Overhaul Of A Cylinder {1000, 7950, 795C}
G3406 Engines Crankshaft
C18 Generator set and C18 Marine Engines Engine Oil Filter Base - Assemble
C18 Generator set and C18 Marine Engines Engine Oil Filter Base - Disassemble
3056E Industrial Engine Inlet and Exhaust Valves - Remove and Install
G3408 and G3412 Engines Cylinder Head Valves
2002/11/01 Change in Torque for Camshaft Gear Bolt {1210, 1212}
2002/11/11 Change in Torque for Camshaft Gear Bolt {1210, 1212}
G3408 and G3412 Engines Cover Group (Rear Housing)
G3408 and G3412 Engines Cover Group (Front Housing)
2002/11/01 New Rod Ends With Grease Fittings Are Available For The Exhaust Bypass Groups {1059}
C7 Urban Transit Bus Engines Fault Logging
G3406 Engines Fan Drive
G3406 and G3412 Generator Set Engines Fan Drive
G3406 and G3412 Generator Set Engines Fan Drive
C7 Urban Transit Bus Engines Engine Crankcase Breather - Clean
SR4 HV and SR4B HV Generators Generator Identification
2002/11/01 New Software Provides Increased Stability At High Idle And The New Software Helps Eliminate Erroneous Logging Of Diagnostic Codes {1902, 7620}
3056E Industrial Engine Inlet and Exhaust Valve Guides - Remove and Install
C9 On-highway Engine Piston and Rings
G3408 and G3412 Engines Engine Speed/Timing Sensor
C18 Generator set and C18 Marine Engines Engine Oil Filter Base - Remove - Engine Mounted Oil Filter Base