Engine Mounted Oil Filter Base
- Position adapter (10) and O-ring seal (9) on engine oil filter base (1) (if equipped).
- Install cover (15) and O-ring seal (13) on engine oil filter base (1). Tighten cover (15) to a torque of
70 ± 10 N·m (52 ± 7 lb ft) (if equipped). - Install O-ring seal (11) onto connector (14) (if equipped).
- Install connector (14) on adapter (10) (if equipped).
- Install elbow (17) and O-ring seal (16) on cover (15) (if equipped).
- Install cover (12) and O-ring seal (8) on engine oil filter base (1) (if equipped).
- Install relief plungers (2) and springs (3) on engine oil filter base (1).
- Install plugs (5) and O-ring seals (4) on engine oil filter base (1).
- Install plugs (6) and O-ring seals (7) on engine oil filter base (1).
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Illustration 1 | g01364553 |
Improper assembly of parts that are spring loaded can cause bodily injury. To prevent possible injury, follow the established assembly procedure and wear protective equipment. |
Note: Certain applications will be equipped with engine oil filters. Refer to Operation and Maintenance Manual, Engine Oil and Filter - Change.
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Illustration 2 | g01364554 |
Improper assembly of parts that are spring loaded can cause bodily injury. To prevent possible injury, follow the established assembly procedure and wear protective equipment. |
- Install drive screw (32).
- Install elbows (24) and O-ring seals (25).
- Install covers (20) and gaskets (21) on engine oil filter bases (23).
- Install engine oil filter bases (23) and gaskets (21) on oil filter adapter (26).
- Install plug (28) and plug (29) on oil filter adapter (26).
Note: If necessary, install the relief plunger, the spring, and the cover in both engine oil filter bases (23).
- Install spring (30) and relief plunger (31).
- Install cover (27).
- Install sampling valve (19) and dust cap (18).
- Install studs (33) on engine oil filter bases (23).
- Install engine oil filters (22).
End By:
- Install the engine oil filter base. Refer to Disassembly and Assembly, "Engine Oil Filter Base - Install".