Lifter Group
Show/hide table
图 1 | g00936107 |
(1) 将 7 个螺栓拧紧至以下扭矩。 ... 60 ± 12 N·m
(45 ± 9 lb ft)
(2) 油孔用的定位销超过轴以下长度。 ... 19.7 mm
(0.78 in)
(3) 气门挺杆
(4) 电子单体喷油器挺杆
(5) 深度从轴底到杯形孔塞的顶沿进行测量。 安装深度 ... 18 ± 0.25 mm
(0.708 ± 0.010 in)
挺杆轴直径 ... 20 ± 0.01 mm
(0.787 ± 0.0004 in)
Caterpillar Information System:
3056E Industrial Engine Inlet Manifold - Install
3056E Industrial Engine Inlet Manifold - Remove
3056E Industrial Engine Inlet Air Temperature Sensor - Remove and Install
SR4 HV and SR4B HV Generators Generator Start-up Checklist
G3406 Engines Cylinder Head Valves
C11 and C13 On-Highway Engines Electronic Unit Injector
3056E Industrial Engine Boost Pressure Sensor - Remove and Install
C11 and C13 On-Highway Engines Engine Design
3056E Industrial Engine Valve Mechanism Cover - Remove and Install
C13 On-highway Engine Engine Design
G3408 and G3412 Engines Piston and Rings
3056E Industrial Engine Exhaust Manifold - Remove and Install - Two-Piece Exhaust Manifold
C11 and C13 On-Highway Engines Rocker Shaft
2002/11/01 A New Special Instruction Provides Information About The Protection Of The Oil System During Major Repair {1000, 1300, 7581}
G3406 and G3412 Generator Set Engines Cover Group (Rear Housing)
G3408 and G3412 Engines Cover Group (Front Housing)
G3408 and G3412 Engines Cover Group (Rear Housing)
2002/11/11 Change in Torque for Camshaft Gear Bolt {1210, 1212}
2002/11/01 Change in Torque for Camshaft Gear Bolt {1210, 1212}
G3408 and G3412 Engines Cylinder Head Valves
3056E Industrial Engine Inlet and Exhaust Valves - Remove and Install
C18 Generator set and C18 Marine Engines Engine Oil Filter Base - Disassemble
C18 Generator set and C18 Marine Engines Engine Oil Filter Base - Assemble
G3406 Engines Crankshaft