Inlet Manifold - Remove
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
- Remove the air inlet hose from the turbocharger and the air inlet elbow.
Show/hide table
Illustration 1 g00936007 - Remove bolts and clips (4).
- Disconnect the harness assembly from electrical connector (7). Disconnect fuel line (9) from air inlet heater (8).
- Remove the air inlet heater from the inlet manifold.
- Disconnect harness assembly (6) at the inlet air temperature sensor.
- Remove boost pressure sensor (5) from inlet manifold (1).
Show/hide table
Illustration 2 g00936035 - Remove bolts (10). Remove the inlet manifold from the cylinder head. Remove the inlet manifold gasket from the cylinder head and the inlet manifold.
- If necessary, remove bolts (3) in order to remove air inlet elbow (2) from inlet manifold (1). Remove the gasket for the air inlet elbow.
Caterpillar Information System:
3056E Industrial Engine Inlet Air Temperature Sensor - Remove and Install
SR4 HV and SR4B HV Generators Generator Start-up Checklist
G3406 Engines Cylinder Head Valves
C11 and C13 On-Highway Engines Electronic Unit Injector
3056E Industrial Engine Boost Pressure Sensor - Remove and Install
C11 and C13 On-Highway Engines Engine Design
3056E Industrial Engine Valve Mechanism Cover - Remove and Install
C13 On-highway Engine Engine Design
G3408 and G3412 Engines Piston and Rings
3056E Industrial Engine Exhaust Manifold - Remove and Install - Two-Piece Exhaust Manifold
2002/11/01 A New Fuel Transfer Pump Group Is Used {1256}
G3408 and G3412 Engines Idler Gear Assembly
3056E Industrial Engine Inlet Manifold - Install
C11 and C13 On-Highway Engines Lifter Group
C11 and C13 On-Highway Engines Rocker Shaft
2002/11/01 A New Special Instruction Provides Information About The Protection Of The Oil System During Major Repair {1000, 1300, 7581}
G3406 and G3412 Generator Set Engines Cover Group (Rear Housing)
G3408 and G3412 Engines Cover Group (Front Housing)
G3408 and G3412 Engines Cover Group (Rear Housing)
2002/11/11 Change in Torque for Camshaft Gear Bolt {1210, 1212}
2002/11/01 Change in Torque for Camshaft Gear Bolt {1210, 1212}
G3408 and G3412 Engines Cylinder Head Valves
3056E Industrial Engine Inlet and Exhaust Valves - Remove and Install
C18 Generator set and C18 Marine Engines Engine Oil Filter Base - Disassemble