Inlet Air Temperature Sensor - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect harness assembly (2).
- Remove inlet air temperature sensor (1) from air inlet elbow (3).
- Remove the O-ring seal from the inlet air temperature sensor.
Show/hide table
Illustration 1 | g00935885 |
- Install a new O-ring seal on the inlet air temperature sensor. Lubricate the O-ring seal with clean engine oil.
- Install inlet air temperature sensor (1) in air inlet elbow (3). Tighten inlet air temperature sensor (1) to a torque of
20 N·m (15 lb ft) . - Connect harness assembly (2).
Show/hide table
Illustration 2 | g00935885 |
Caterpillar Information System:
SR4 HV and SR4B HV Generators Generator Start-up Checklist
G3406 Engines Cylinder Head Valves
C11 and C13 On-Highway Engines Electronic Unit Injector
3056E Industrial Engine Boost Pressure Sensor - Remove and Install
C11 and C13 On-Highway Engines Engine Design
3056E Industrial Engine Valve Mechanism Cover - Remove and Install
C13 On-highway Engine Engine Design
G3408 and G3412 Engines Piston and Rings
3056E Industrial Engine Exhaust Manifold - Remove and Install - Two-Piece Exhaust Manifold
2002/11/01 A New Fuel Transfer Pump Group Is Used {1256}
G3408 and G3412 Engines Idler Gear Assembly
416C, 426C, 428C, 436C and 438C Backhoe Loaders Emissions Certification Film
3056E Industrial Engine Inlet Manifold - Remove
3056E Industrial Engine Inlet Manifold - Install
C11 and C13 On-Highway Engines Lifter Group
C11 and C13 On-Highway Engines Rocker Shaft
2002/11/01 A New Special Instruction Provides Information About The Protection Of The Oil System During Major Repair {1000, 1300, 7581}
G3406 and G3412 Generator Set Engines Cover Group (Rear Housing)
G3408 and G3412 Engines Cover Group (Front Housing)
G3408 and G3412 Engines Cover Group (Rear Housing)
2002/11/11 Change in Torque for Camshaft Gear Bolt {1210, 1212}
2002/11/01 Change in Torque for Camshaft Gear Bolt {1210, 1212}
G3408 and G3412 Engines Cylinder Head Valves
3056E Industrial Engine Inlet and Exhaust Valves - Remove and Install