Idler Gear Assembly
Show/hide table
Illustration 1 | g01412817 |
(A) Bearing bore
- Bore in bearing of gear after assembly ... 63.592 ± 0.013 mm (2.5036 ± 0.0005 inch)
- Diameter of bearing surface of the shaft ... 63.500 ± 0.013 mm (2.5000 ± 0.0005 inch)
(B) Install the bearing from the front face of the gear assembly to the following depth. ... 0.38 ± 0.25 mm (0.015 ± 0.010 inch)
(C) Length of gear ... 45.78 mm (1.802 inch)
Length of the bearing surface of the shaft ... 50.85 ± 0.05 mm (2.002 ± 0.002 inch)
Caterpillar Information System:
416C, 426C, 428C, 436C and 438C Backhoe Loaders Emissions Certification Film
G3520C and G3520E Engines Spark Plug
G3500 Engines Exhaust Manifold - Dry
3056E Industrial Engine Exhaust Manifold - Remove and Install - Three-Piece Exhaust Manifold
SR4 HV and SR4B HV Generators Generator Set - Test
2002/12/01 New Thermocouples Are Used To Measure The Engine Exhaust Temperature {1059, 1919}
G3500 Engines Exhaust Manifold - Dry
C7 and C9 On-Highway Engines Air Inlet Heater Circuit - Test
Test Sequence for Pencil Type Fuel Nozzles{1254} Test Sequence for Pencil Type Fuel Nozzles{1254}
3056E Industrial Engine Fuel Injection Nozzles - Install
3056E Industrial Engine Fuel Injection Nozzles - Remove
G3520C and G3520E Generator Set Engines Cat Data Link - Test
2002/11/01 A New Fuel Transfer Pump Group Is Used {1256}
3056E Industrial Engine Exhaust Manifold - Remove and Install - Two-Piece Exhaust Manifold
G3408 and G3412 Engines Piston and Rings
C13 On-highway Engine Engine Design
3056E Industrial Engine Valve Mechanism Cover - Remove and Install
C11 and C13 On-Highway Engines Engine Design
3056E Industrial Engine Boost Pressure Sensor - Remove and Install
C11 and C13 On-Highway Engines Electronic Unit Injector
G3406 Engines Cylinder Head Valves
SR4 HV and SR4B HV Generators Generator Start-up Checklist
3056E Industrial Engine Inlet Air Temperature Sensor - Remove and Install
3056E Industrial Engine Inlet Manifold - Remove