Exhaust Manifold - Dry
Show/hide table
Illustration 1 | g00994403 |
Top view |
Note: Apply 5P-3931 Anti-Seize Compound on the following items on the exhaust manifolds:
- Threads of bolts
- Plugs
- Studs
- Nuts
(1) Bolt
Torque ...
- Tighten the bolts again.
Torque ...
47 ± 5 N·m (35 ± 4 lb ft)
(2) Clamps
- Torque ...
6.5 ± 2.0 N·m (58 ± 18 lb in)
Apply 5P-3931 Anti-Seize Compound to the bearing surfaces, to the clamp bolt, and to the inside diameter of the clamp.
(3) Heat shield
(4) Stud
- Torque ...
35 ± 5 N·m (25 ± 4 lb ft)
Show/hide table
Illustration 2 | g00994378 |
Section A-A |
(5) Seal
(6) Bolt
- Torque ...
55 ± 5 N·m (41 ± 4 lb ft)
(7) Cylinder head
(8) Spacer
(9) Cylinder block
Caterpillar Information System:
3056E Industrial Engine Exhaust Manifold - Remove and Install - Three-Piece Exhaust Manifold
SR4 HV and SR4B HV Generators Generator Set - Test
2002/12/01 New Thermocouples Are Used To Measure The Engine Exhaust Temperature {1059, 1919}
G3500 Engines Exhaust Manifold - Dry
C7 and C9 On-Highway Engines Air Inlet Heater Circuit - Test
Test Sequence for Pencil Type Fuel Nozzles{1254} Test Sequence for Pencil Type Fuel Nozzles{1254}
3056E Industrial Engine Fuel Injection Nozzles - Install
3056E Industrial Engine Fuel Injection Nozzles - Remove
G3520C and G3520E Generator Set Engines Cat Data Link - Test
G3520B Industrial Engine MID 036 - CID 1720 - FMI 09 Turbocharger Compressor Bypass Valve Actuator not communicating on link
G3520B Industrial Engine MID 036 - CID 1440 - FMI 09 Unable to communicate with Throttle Actuator Drv
G3408C and G3412C Engines Engine Oil Filter Base
G3520C and G3520E Engines Spark Plug
416C, 426C, 428C, 436C and 438C Backhoe Loaders Emissions Certification Film
G3408 and G3412 Engines Idler Gear Assembly
2002/11/01 A New Fuel Transfer Pump Group Is Used {1256}
3056E Industrial Engine Exhaust Manifold - Remove and Install - Two-Piece Exhaust Manifold
G3408 and G3412 Engines Piston and Rings
C13 On-highway Engine Engine Design
3056E Industrial Engine Valve Mechanism Cover - Remove and Install
C11 and C13 On-Highway Engines Engine Design
3056E Industrial Engine Boost Pressure Sensor - Remove and Install
C11 and C13 On-Highway Engines Electronic Unit Injector
G3406 Engines Cylinder Head Valves