Engine Oil Filter Base
Show/hide table
Illustration 1 | g01407889 |
(3) Engine oil filter assembly |
(1) 4N-8150 Spring
- Length under test force ... 55.24 mm (2.175 inch)
- Test force ... 75.619 ± 5.800 N (17.000 ± 1.304 lb)
- Free length after test ... 93.726 mm (3.6900 inch)
- Outside diameter ... 20.6 mm (0.81 inch)
- Test force ... 75.619 ± 5.800 N (17.000 ± 1.304 lb)
Note: Apply red Loctite 271 to the tapered end threads of the hollow stud for a length of 10.2 ± 1.5 mm (0.40 ± 0.06 inch).
(2) Torque for the hollow stud ... 80 ± 14 N·m (60 ± 10 lb ft)
Pressure difference for opening of the engine oil filter bypass valve ... 255 ± 20 kPa (37 ± 3 psi)
Caterpillar Information System:
G3406 Engines Engine Oil Filter Base
2002/12/16 New Water Seals Provide Increased Stability At Higher Temperatures {1100, 1124}
2010/10/06 New Water Seals Provide Increased Stability At Higher Temperatures {1100, 1124}
G3408C and G3412C Engines Cylinder Head
C7 and C9 On-Highway Engines ECM Memory - Test
C7 and C9 On-Highway Engines Engine Temperature Sensor Open or Short Circuit - Test
G3516B Engines Exhaust Port Temperature (High)
G3516B Engines Engine Coolant Temperature (High)
G3516B Engines Detonation
C7 and C9 On-Highway Engines 5 Volt Engine Pressure Sensor Supply Circuit - Test
2002/11/04 Do Not Use Ether with Machines that are Equipped with a Starting Aid {1412}
2002/11/01 Installation Procedure For Spark Plugs And Ignition Transformers For Ignitions On Engines That Must Meet The Requirements Of The Canadian Standards Association (CSA) {1555, 1561}
G3520B Industrial Engine MID 036 - CID 1440 - FMI 09 Unable to communicate with Throttle Actuator Drv
G3520B Industrial Engine MID 036 - CID 1720 - FMI 09 Turbocharger Compressor Bypass Valve Actuator not communicating on link
G3520C and G3520E Generator Set Engines Cat Data Link - Test
3056E Industrial Engine Fuel Injection Nozzles - Remove
3056E Industrial Engine Fuel Injection Nozzles - Install
Test Sequence for Pencil Type Fuel Nozzles{1254} Test Sequence for Pencil Type Fuel Nozzles{1254}
C7 and C9 On-Highway Engines Air Inlet Heater Circuit - Test
G3500 Engines Exhaust Manifold - Dry
2002/12/01 New Thermocouples Are Used To Measure The Engine Exhaust Temperature {1059, 1919}
SR4 HV and SR4B HV Generators Generator Set - Test
3056E Industrial Engine Exhaust Manifold - Remove and Install - Three-Piece Exhaust Manifold
G3500 Engines Exhaust Manifold - Dry