Illustration 1 | g01407479 |
Note: Use clean engine oil to lubricate the threads of the cylinder head bolts before assembly.
Use the following procedure to tighten the cylinder head bolts:
- Torque for bolt (1) through bolt (20) in a numerical sequence to 270 ± 27 N·m (200 ± 20 lb ft)
- Again torque the bolt (1) through bolt (20) in a numerical sequence to 450 ± 20 N·m (332 ± 15 lb ft).
- Finally torque the bolt (1) through bolt (20) in a numerical sequence to 450 ± 20 N·m (332 ± 15 lb ft).
- Install the rocker arm assemblies onto the cylinder head.
- Torque for the bolt (21) through bolt (26) in a numerical sequence to 270 ± 27 N·m (200 ± 20 lb ft)
- Again torque the bolt (21) through bolt (26) in a numerical sequence to 450 ± 20 N·m (332 ± 15 lb ft).
- Finally torque the bolt (21) through bolt (26) in a numerical sequence to 450 ± 20 N·m (332 ± 15 lb ft).
- Torque the bolt (27) through bolt (39) to 43 ± 7 N·m (32 ± 5 lb ft).
Note: Tighten the bolts only after the cylinder head bolts have been given final torque.
(40) Torque for taperlock studs ... 35 ± 5 N·m (26 ± 4 lb ft)
Illustration 2 | g01017447 |
(A) Height of new cylinder head ... 125.00 ± 0.25 mm (4.921 ± 0.010 inch)
Illustration 3 | g01404145 |
Note: Use Loctite Hi-Temp Flange Sealant on the cup plugs.
(E) The cup plugs are installed into the cylinder head at the following depth. ... 4.5 ± 0.5 mm (0.18 ± 0.02 inch)
(F) The cup plugs are installed into the cylinder head at the following depth. ... 2.0 ± 0.5 mm (0.08 ± 0.02 inch)
(G) The cup plugs are installed into the cylinder head at the following depth. ... 0.8 ± 0.5 mm (0.03 ± 0.02 inch)
Illustration 4 | g01417479 |
(41) Apply, Loctite Hi-Temp Flange Sealant on the cup plugs. Install the cup plugs in front side of each cylinder head after the cylinder head is installed on the cylinder block.
(42) Use Loctite Hi-Temp Flange Sealant on the cup plugs.
Illustration 5 | g01407482 |
Note: Lubricate the bore of the O-ring seal (44) lightly with the silicone compound prior to installation of the adapter.
Note: Apply 4C-5599 Anti-Seize Compound onto the threads of the adapter prior to installation.
(43) Torque for adapter ... 95 ± 7 N·m (70 ± 5 lb ft)