Engine Oil Pan
Show/hide table
图 1 | g01101654 |
典型仰视图 |
涂抹 4C-9612 硅密封胶 至油底壳密封表面上的四片区域。 范围是标记位置 (Y) 。 范围在油底壳角落的以下位置:
- 前壳体和缸体前部的连接点
- 飞轮壳体和缸体后部的连接点
采用以下步骤来拧紧油底壳螺栓。
将 4 个螺栓 (X) 拧紧至下述扭矩。 ... 31 ± 3 N·m (23 ± 2 lb ft)
从螺栓 (Z) 开始并按逆时针次序拧紧所有其余螺栓。
将螺栓拧紧至下述扭矩。 ... 31 ± 3 N·m (23 ± 2 lb ft)
从螺栓 (Z) 再次开始并按逆时针次序拧紧所有其余螺栓。
将螺栓拧紧至下述扭矩。 ... 31 ± 3 N·m (23 ± 2 lb ft)
将放油螺塞拧紧至下述扭矩。 ... 35 ± 5 N·m (26 ± 4 lb ft)
Caterpillar Information System:
3056E Industrial Engine Engine Oil Pan - Remove and Install
P16, P20, P25, P28, P40 and P60 Pulverizer Welding on Machines and Engines with Electronic Controls
C9 Marine Generator Set Engines Fuel System Pressure - Test
3056E Industrial Engine Cylinder Liner - Install
3056E Industrial Engine Cylinder Liner - Remove
C15 Engine Reference Material
G3500 Engines Engine Design
G3500 Engines Engine Design
G3500 Engines Engine Design
P16, P20, P25, P28, P40 and P60 Pulverizer Work Tool Installation and Removal
2002/11/01 Do Not Use Ether with Engines that are Equipped with a Starting Aid {1412}
C9 Marine Engines and C9 Marine Generator Sets Turbocharger
2002/11/01 Installation Procedure For Spark Plugs And Ignition Transformers For Ignitions On Engines That Must Meet The Requirements Of The Canadian Standards Association (CSA) {1555, 1561}
2002/11/04 Do Not Use Ether with Machines that are Equipped with a Starting Aid {1412}
C7 and C9 On-Highway Engines 5 Volt Engine Pressure Sensor Supply Circuit - Test
G3516B Engines Detonation
G3516B Engines Engine Coolant Temperature (High)
G3516B Engines Exhaust Port Temperature (High)
C7 and C9 On-Highway Engines Engine Temperature Sensor Open or Short Circuit - Test
C7 and C9 On-Highway Engines ECM Memory - Test
G3408C and G3412C Engines Cylinder Head
2010/10/06 New Water Seals Provide Increased Stability At Higher Temperatures {1100, 1124}
2002/12/16 New Water Seals Provide Increased Stability At Higher Temperatures {1100, 1124}
G3406 Engines Engine Oil Filter Base