Cylinder Liner - Remove
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 5P-8665 | Cylinder Liner Puller | 1 |
Start By:
- Remove the cylinder head. Refer to Disassembly and Assembly, "Cylinder Head - Remove".
- Remove the pistons and connecting rods. Refer to Disassembly and Assembly, "Pistons and Connecting Rods - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Before you proceed with the removal of the cylinder liner, check the cylinder liners for wear or for damage. Check the inner diameter of each cylinder liner at the top, the middle, and the bottom. Check the inner diameter at two places that are 180 degrees away from each other. The maximum wear for the cylinder liners is
- Rotate the crankshaft in order to gain access to the cylinder liner. Place a protective cover on the crankshaft in order to prevent damage.
Show/hide table
Illustration 1 g00953356 - Use Tooling (A) to remove cylinder liner (1).
Caterpillar Information System:
C15 Engine Reference Material
G3500 Engines Engine Design
G3500 Engines Engine Design
G3500 Engines Engine Design
P16, P20, P25, P28, P40 and P60 Pulverizer Work Tool Installation and Removal
2002/11/01 Do Not Use Ether with Engines that are Equipped with a Starting Aid {1412}
C9 Marine Engines and C9 Marine Generator Sets Turbocharger
G3500 Engines Engine Oil Temperature Regulator
2002/11/01 Precautions for Cleaning an Engine {1000}
2002/10/28 Precautions for Cleaning an Engine {1000}
C12 Marine Engines Transmission Oil Temperature Sensor
C11, C13, and C15 On-highway Engines Fuel System - Prime
3056E Industrial Engine Cylinder Liner - Install
C9 Marine Generator Set Engines Fuel System Pressure - Test
P16, P20, P25, P28, P40 and P60 Pulverizer Welding on Machines and Engines with Electronic Controls
3056E Industrial Engine Engine Oil Pan - Remove and Install
C9 On-highway Engine Engine Oil Pan
2002/11/01 Installation Procedure For Spark Plugs And Ignition Transformers For Ignitions On Engines That Must Meet The Requirements Of The Canadian Standards Association (CSA) {1555, 1561}
2002/11/04 Do Not Use Ether with Machines that are Equipped with a Starting Aid {1412}
C7 and C9 On-Highway Engines 5 Volt Engine Pressure Sensor Supply Circuit - Test
G3516B Engines Detonation
G3516B Engines Engine Coolant Temperature (High)
G3516B Engines Exhaust Port Temperature (High)
C7 and C9 On-Highway Engines Engine Temperature Sensor Open or Short Circuit - Test