G3500 Engines Caterpillar


Engine Design

Usage:

G3508 2TJ


Illustration 1g01393308
Cylinder and valve location
(A) Inlet valves
(B) Exhaust valves

Number and arrangement of cylinders ... 60 degree V−8

Valves per cylinder ... 4

Displacement ... 34.5 L (2105.3 cu in)

Bore ... 170 mm (6.7 inch)

Stroke ... 190 mm (7.5 inch)

Combustion ... Spark Ignited

When the crankshaft is viewed from the flywheel end, the crankshaft rotates in the following direction: ... Counterclockwise

Note: The front end of the engine is opposite the flywheel end of the engine. The left side and the right side of the engine are determined from the flywheel end. The number 1 cylinder is the front cylinder on the right side. The number 2 cylinder is the front cylinder on the left side.

Caterpillar Information System:

P16, P20, P25, P28, P40 and P60 Pulverizer Work Tool Installation and Removal
2002/11/01 Do Not Use Ether with Engines that are Equipped with a Starting Aid {1412}
C9 Marine Engines and C9 Marine Generator Sets Turbocharger
G3500 Engines Engine Oil Temperature Regulator
2002/11/01 Precautions for Cleaning an Engine {1000}
2002/10/28 Precautions for Cleaning an Engine {1000}
C12 Marine Engines Transmission Oil Temperature Sensor
C11, C13, and C15 On-highway Engines Fuel System - Prime
C9 On-highway Engine Electronic Unit Injector
C9 Engines for Caterpillar Built Machines Unit Injector Hydraulic Pump
C7 and C9 On-Highway Engines Torque Limit Switch Circuit - Test
C7 and C9 On-Highway Engines Service Brake Pedal Position (Switch 2) Circuit - Test
G3500 Engines Engine Design
G3500 Engines Engine Design
C15 Engine Reference Material
3056E Industrial Engine Cylinder Liner - Remove
3056E Industrial Engine Cylinder Liner - Install
C9 Marine Generator Set Engines Fuel System Pressure - Test
P16, P20, P25, P28, P40 and P60 Pulverizer Welding on Machines and Engines with Electronic Controls
3056E Industrial Engine Engine Oil Pan - Remove and Install
C9 On-highway Engine Engine Oil Pan
2002/11/01 Installation Procedure For Spark Plugs And Ignition Transformers For Ignitions On Engines That Must Meet The Requirements Of The Canadian Standards Association (CSA) {1555, 1561}
2002/11/04 Do Not Use Ether with Machines that are Equipped with a Starting Aid {1412}
C7 and C9 On-Highway Engines 5 Volt Engine Pressure Sensor Supply Circuit - Test
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.