Fan Drive
Show/hide table
Illustration 1 | g00936782 |
(1) V-belt
Adjust the belt tension according to Specifications, "Belt Tension Chart".
(2) Lip seal
For installation, lubricate the lip seal with 1P-0808 Multipurpose Grease .
(3) Stud
- Torque ... 65 ± 10 N·m (50 ± 7 lb ft)
(4) Fitting
Pump 1P-0808 Multipurpose Grease into the grease fitting until the grease is purged through the relief fitting.
(5) Relief fitting
Caterpillar Information System:
C7 Urban Transit Bus Engines Fault Logging
2002/11/01 New Rod Ends With Grease Fittings Are Available For The Exhaust Bypass Groups {1059}
G3408 and G3412 Engines Carburetor Control Linkage
C7 and C9 On-Highway Engines Customer Specified Parameters
C7 Petroleum Engines Electronic Control System Components
2003/02/01 A New Overhaul Protection Group Is Available For The Overhaul Of A Cylinder {1000, 7950, 795C}
G3406 Engines Crankshaft
C18 Generator set and C18 Marine Engines Engine Oil Filter Base - Assemble
C18 Generator set and C18 Marine Engines Engine Oil Filter Base - Disassemble
3056E Industrial Engine Inlet and Exhaust Valves - Remove and Install
G3408 and G3412 Engines Cylinder Head Valves
2002/11/01 Change in Torque for Camshaft Gear Bolt {1210, 1212}
G3406 and G3412 Generator Set Engines Fan Drive
G3406 and G3412 Generator Set Engines Fan Drive
C7 Urban Transit Bus Engines Engine Crankcase Breather - Clean
SR4 HV and SR4B HV Generators Generator Identification
2002/11/01 New Software Provides Increased Stability At High Idle And The New Software Helps Eliminate Erroneous Logging Of Diagnostic Codes {1902, 7620}
3056E Industrial Engine Inlet and Exhaust Valve Guides - Remove and Install
C9 On-highway Engine Piston and Rings
G3408 and G3412 Engines Engine Speed/Timing Sensor
C18 Generator set and C18 Marine Engines Engine Oil Filter Base - Remove - Engine Mounted Oil Filter Base
C7 and C9 On-Highway Engines 0190-00 Engine Overspeed Warning (35)
C7 Engines for Caterpillar Built Machines Electronic Unit Injector
3054E Industrial Engine Inlet and Exhaust Valve Seat Inserts - Remove and Install