The following procedure will allow the user to select one of the ten work tools that are programmed into the monitor and machine ECU.
- The "Home" screen of the monitor is displayed when the key switch for the machine is turned to the ON position. Press the "Menu" key to display the main menu options.
Show/hide table
Illustration 2 g03583761 - Use the arrows to select "Work Tool Select" from the "Main Menu". Press the OK key.
Show/hide table
Illustration 3 g03583762 - Use the arrows to highlight the desired work tool from the "Work Tool Select" menu. Press the OK key to select the work tool.
Note: The selected work tool will now appear in the message bar at top of the monitor screen.
Illustration 1 | g03583758 |
Illustration 4 | g03583764 |
The selected work tool will now appear at the bottom of the Home Screen.
Note: To change the parameters of the work tool, refer to Testing and Adjusting, "Work Tool Parameter - Program" for more information.
Cat Electronic Technician Procedure
The following procedure will allow the user to select one of the ten work tools that are programmed into the machine ECU using Cat Electronic Technician.
- Connect the Cat Electronic Technician to the diagnostic connector located behind the operator seat of the cab.
Show/hide table
Illustration 6 g02713758 - Start Cat Electronic Technician.
Show/hide table
Illustration 7 g02713761 - Select the ECU for "Machine Control".
Show/hide table
Illustration 8 g02714358 - Select "Tool Configuration" from the "Service" menu.
Show/hide table
Illustration 9 g02722754 Work tool list (typical example) - Highlight the desired tool. Click on "Activate" in the bottom left corner of the screen. The selected tool will now be listed as the "Active Tool" at the top of the screen.
Illustration 5 | g02713701 |
Diagnostic connector for Cat Electronic Technician |
Note: To change the parameters of the work tool, refer to Testing and Adjusting, "Work Tool Parameter - Program" for more information.