Initial Startup Procedure - System Pre-startup
注: 本程序只应由持有卡特彼勒合格证书的维修人员来进行。 本程序应在系统已被锚固到位,所有线路已被正确连接之后才能进行。
Show/hide table
注意 |
---|
在系统初始起动之前必须首先完成下列程序: 系统运作、测试和调整, RENR2476, "振动传感器归零 - 标定", 系统运作、测试和调整, RENR2476, "转子位置传感器 - 调整" 和 系统运作、测试和调整, RENR2476, "转子位置传感器 - 标定" |
在通电前,进行下列预起动程序。
- 将UPS的按键开关 (1) 转动到"旁路"位置。
Show/hide table
图 1 | g01241991 |
用户界面面板 (1) 按键开关 |
- 断开输出隔离开关 (3) ,如有配备。
Show/hide table
图 2 | g01241996 |
(2) 可选择的旁路开关 (3) 可选择的输出隔离开关 (4) 可选择的输入隔离开关 |
- 断开输入隔离开关 (4) ,如有配备。
- 断开旁路开关 (2) ,如有配备。
Caterpillar Information System:
G3408C and G3412C Engines Exhaust Manifold - Remove
3412C Engine Fuel Injection Lines
3412C Engine Fuel Transfer Pump
Product Identification Numbers (PIN) Location Guide Skid Steer Loader
2001/08/01 A New Pyrometer Is Available {7451, 7466}
G3408C and G3412C Engines Exhaust Bypass - Assemble
3412C Engine Vibration Damper and Pulley
G3408C and G3412C Engines Exhaust Bypass - Disassemble
Use Proper Handling During Shipment and Installation of the Water Pumps{1361} Use Proper Handling During Shipment and Installation of the Water Pumps{1361}
G3408C and G3412C Engines Exhaust Bypass - Install
G3408C and G3412C Engines Exhaust Bypass - Remove
Product Identification Numbers (PIN) Location Guide Forwarder
G3408C and G3412C Engines Exhaust Manifold - Install
3412C Engine Air Inlet and Exhaust Lines
G3408C and G3412C Engines Aftercooler - Remove
3412C Engine Fuel Injection Pump
3412C Engine Fuel Injection Pump Housing
2001/06/01 Identification of Current Fuel Injectors for 3600 Diesel Engines {1290}
G3408C and G3412C Engines Aftercooler - Install
Retrofitting The Bendix Dura-Flo 596 Air Compressor to Existing Industrial Engines and Truck Engines{1803} Retrofitting The Bendix Dura-Flo 596 Air Compressor to Existing Industrial Engines and Truck Engines{1803}
G3408C and G3412C Engines Turbocharger - Remove
G3408C and G3412C Engines Turbocharger - Install
3412C Engine Coolant Temperature Sensor
3412C Engine Turbocharger Outlet Pressure Sensor