Turbocharger - Remove
Removal Procedure
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove tube assembly (1) .
Show/hide table
Illustration 1 | g00785562 |
- Remove tube assembly (2) and (3) . Plug and cap all openings immediately.
- Remove tube assembly (6) . Plug and cap all openings immediately.
Show/hide table
Illustration 2 | g00785565 |
Show/hide table
Illustration 3 | g00785567 |
- Remove tube assembly (7) . Plug and cap all openings immediately.
- Remove bolts (5) from elbow (4) .
- Loosen hose clamps (8) .
- Disconnect tube assembly (9) . Plug and cap all openings immediately.
- Remove four bolts (10) and exhaust elbow (11) .
- Attach a suitable lifting device to turbocharger (12) .
Show/hide table
Illustration 4 | g00785568 |
- Remove four nuts (13) and remove turbocharger (12) . The weight of turbocharger (12) is approximately 57 kg (125 lb).
Caterpillar Information System:
Retrofitting The Bendix Dura-Flo 596 Air Compressor to Existing Industrial Engines and Truck Engines{1803} Retrofitting The Bendix Dura-Flo 596 Air Compressor to Existing Industrial Engines and Truck Engines{1803}
G3408C and G3412C Engines Aftercooler - Install
2001/06/01 Identification of Current Fuel Injectors for 3600 Diesel Engines {1290}
3412C Engine Fuel Injection Pump Housing
3412C Engine Fuel Injection Pump
G3408C and G3412C Engines Aftercooler - Remove
3412C Engine Air Inlet and Exhaust Lines
G3408C and G3412C Engines Exhaust Manifold - Install
UPS 250 and UPS 300 Uninterruptible Power Supplies Initial Startup Procedure - System Pre-startup
G3408C and G3412C Engines Exhaust Manifold - Remove
3412C Engine Fuel Injection Lines
3412C Engine Fuel Transfer Pump
G3408C and G3412C Engines Turbocharger - Install
3412C Engine Coolant Temperature Sensor
3412C Engine Turbocharger Outlet Pressure Sensor
G3408C and G3412C Engines Engine Oil Cooler - Remove
3412C Engine Engine Oil Pressure Sensor
3412C Engine Atmospheric Pressure Sensor
3412C Engine Fuel Pressure Sensor
G3408C and G3412C Engines Engine Oil Cooler - Install
3412C Engine Fuel Temperature Sensor
3412C Engine Speed and Timing Sensor
G3408C and G3412C Engines Timing Gear Cover - Remove and Install
G3408C and G3412C Engines Valve Cover - Remove and Install