Engine Oil Cooler - Remove
Removal Procedure
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect line (1). Plug and cap all openings immediately.
Show/hide table
 | |
| Illustration 1 | g00785627 |
- Remove bolt and washer (2). Move fumes disposal tube (3) out of the way.
- Remove two bolts and washers (4). Move detonation sensor (5) out of the way.
Show/hide table
 | |
| Illustration 2 | g00785637 |
- Remove three bolts and washers (6) .
- Remove engine oil cooler bonnet (7). Check the condition of the O-ring seal between the engine oil cooler bonnet and the engine oil cooler. If the O-ring seal is worn or damaged, use a new part for replacement.
Show/hide table
 | |
| Illustration 3 | g00785642 |
- Remove two bolts (8) and two bolts (9.)
- Remove engine oil cooler (11). Remove gasket (10) .
Show/hide table
 | |
| Illustration 4 | g00785656 |
- Remove adapter (13) from the engine oil cooler. Remove two O-ring seals (12) from adapter (13) .
Show/hide table
 | |
| Illustration 5 | g00785658 |
- Clean the tube bundles of the engine oil cooler with a 3.18 mm (0.125 inch) diameter rod.
Show/hide table
 | |
| Illustration 6 | g00785662 |
Caterpillar Information System:
3412C Engine Turbocharger Outlet Pressure Sensor
3412C Engine Coolant Temperature Sensor
G3408C and G3412C Engines Turbocharger - Install
G3408C and G3412C Engines Turbocharger - Remove
Retrofitting The Bendix Dura-Flo 596 Air Compressor to Existing Industrial Engines and Truck Engines{1803} Retrofitting The Bendix Dura-Flo 596 Air Compressor to Existing Industrial Engines and Truck Engines{1803}
G3408C and G3412C Engines Aftercooler - Install
2001/06/01 Identification of Current Fuel Injectors for 3600 Diesel Engines {1290}
3412C Engine Fuel Injection Pump Housing
3412C Engine Fuel Injection Pump
G3408C and G3412C Engines Aftercooler - Remove
3412C Engine Air Inlet and Exhaust Lines
G3408C and G3412C Engines Exhaust Manifold - Install
3412C Engine Engine Oil Pressure Sensor
3412C Engine Atmospheric Pressure Sensor
3412C Engine Fuel Pressure Sensor
G3408C and G3412C Engines Engine Oil Cooler - Install
3412C Engine Fuel Temperature Sensor
3412C Engine Speed and Timing Sensor
G3408C and G3412C Engines Timing Gear Cover - Remove and Install
G3408C and G3412C Engines Valve Cover - Remove and Install
Product Identification Numbers (PIN) Location Guide Asphalt Paver
G3408C and G3412C Engines Valve Cover Base - Remove
G3408C and G3412C Engines Valve Cover Base - Install
G3408C and G3412C Engines Rocker Shaft and Push Rod - Remove