Rocker Arm and Shaft - Remove
Removal Procedure
Start By:
- Remove the valve mechanism cover. Refer to Disassembly and Assembly, "Valve Mechanism Cover - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove nuts (1) and bolt (2). Begin with the end brackets and move toward the center.
Show/hide table
Illustration 1 | g00572217 |
3056 Engine |
Note: It is not necessary to remove the oil supply tube in order to remove the rocker shaft assembly and the pushrods.
- Remove rocker shaft assembly (3) .
- Remove the oil seal from the oil supply passage in the cylinder head.
- Remove pushrods (4). Place an identification mark on the pushrods for installation.
Show/hide table
Illustration 2 | g00572218 |
3056 Engine |
Caterpillar Information System:
G3500 Engines Restriction of Air Inlet and Exhaust
3054, 3054B and 3056 Marine Engines Sea Water Strainer - Clean/Inspect
G3406 Engine Governor - Adjust
3054, 3054B and 3056 Marine Engines Vibration Damper and Pulley - Remove and Install
G3304 and G3306 Engines Testing the Cooling System
G3406 Engine Visual Inspection
C7 and C9 On-Highway Engines Engine Misfires, Runs Rough or Is Unstable
3054 and 3056 Marine Generator Sets Fuel System Primary Filter (Water Separator) Element - Replace
C-10, C-12, C-15 and C-16 Industrial Engines Diagnostic Lamp Circuit - Test
G3304 and G3306 Engines Cylinder Block
UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Specifications
3054 and 3056 Marine Generator Sets Engine Oil and Filter - Change
3054, 3054B and 3056 Marine Engines Valve Mechanism Cover - Remove and Install - 3056 Engine
3054 and 3056 Marine Generator Set Engines Rocker Arm and Shaft - Install
3054 and 3056 Marine Generator Set Engines Expansion Tank - Remove and Install
3126B and 3126E On-highway Engines Check Engine Lamp Circuit - Test
C-10, C-12, C-15 and C-16 Industrial Engines Switch Circuits - Test
3054, 3054B and 3056 Marine Engines Reference Material
G3600 Engines Customer Passwords
3114, 3116, and 3126 Engines for Caterpillar Built Machines Inlet and Exhaust Valve Guides - Remove and Install
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Fuel Injection Lines
UPS 250 and UPS 300 Uninterruptible Power Supplies Status Messages
3054, 3054B and 3056 Marine Engines Installation Guide General Information
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Crankshaft Pulley