3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Caterpillar


Crankshaft Pulley

Usage:

CB-214D 1TZ

3003 Engine




Illustration 1g00742413

3003 engine

(1) Tighten the crankshaft pulley nut to the following torque. ... 123 N·m (91 lb ft)

3013, 3014, and 3024 Engines




Illustration 2g00742410

3013, 3014, and 3024 engines

(1) Tighten the crankshaft pulley nut to the following torque. ... 304 N·m (224 lb ft)

Caterpillar Information System:

3054, 3054B and 3056 Marine Engines Installation Guide General Information
UPS 250 and UPS 300 Uninterruptible Power Supplies Status Messages
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Fuel Injection Lines
3114, 3116, and 3126 Engines for Caterpillar Built Machines Inlet and Exhaust Valve Guides - Remove and Install
G3600 Engines Customer Passwords
3054, 3054B and 3056 Marine Engines Reference Material
C-10, C-12, C-15 and C-16 Industrial Engines Switch Circuits - Test
3126B and 3126E On-highway Engines Check Engine Lamp Circuit - Test
3054 and 3056 Marine Generator Set Engines Expansion Tank - Remove and Install
3054 and 3056 Marine Generator Set Engines Rocker Arm and Shaft - Install
3054, 3054B and 3056 Marine Engines Valve Mechanism Cover - Remove and Install - 3056 Engine
3054 and 3056 Marine Generator Set Engines Rocker Arm and Shaft - Remove
3126B Industrial Engines CID 0320 FMI 02 Speed/Timing Sensor Loss of Signal
320B, 322B, 325B, 330B and 345B Excavators SmartBoom Operation - If Equipped
3126B Industrial Engines CID 0320 FMI 11 Speed/Timing Sensor mechanical failure
Electronic Modular Control Panel II (EMCP II) AL Fault Codes
Electronic Modular Control Panel II (EMCP II) Alarm Mode
Electronic Modular Control Panel II (EMCP II) Shutdown Mode - For MUI Engines
Electronic Modular Control Panel II (EMCP II) Shutdown Mode - For PEEC and EUI Engines
Electronic Modular Control Panel II (EMCP II) Customer Interface Module
Electronic Modular Control Panel II (EMCP II) Diagnostic Codes
Electronic Modular Control Panel II (EMCP II) Electronic Control Module (Engine) - EUI Engines Only
C-9 Industrial Engine E095 Fuel Filter Restriction Warning
C-10, C-12, C-15 and C-16 Industrial Engines PTO Ramp Up/Down Switch Circuit - Test
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.