E095 Fuel Filter Restriction Warning
产生此代码的情况:
发动机已经运转 60 秒钟，并且电子控制模块（ECM）已确认燃油压力低于 250 kPa (36 psi) 达 10 秒钟。
系统响应:
ECM 将会记录该事件。
燃油压力升至 260 kPa (37 psi) 以上达 4 秒钟时，将停用燃油压力偏低警告。
发动机的运转未受影响。
测试步骤 1. 更换燃油滤清器
- 更换发动机的燃油滤清器。 向燃油系统充油。
请参阅发动机的操作和保养手册以了解正确步骤。
- 起动发动机。 使用 Caterpillar 电子技师（ET）检查是否发生其他事件。
预期结果:
事件没有重现。
结果:
- 正常 - 事件没有重现。停止
- 异常 - ECM 检测到燃油系统中燃油压力异常。
修复: 关于测试燃油系统的资料，请参阅系统操作/测试和调整, "燃油系统压力 - 测试"。
停止
Caterpillar Information System:
Electronic Modular Control Panel II (EMCP II) Electronic Control Module (Engine) - EUI Engines Only
Electronic Modular Control Panel II (EMCP II) Diagnostic Codes
Electronic Modular Control Panel II (EMCP II) Customer Interface Module
Electronic Modular Control Panel II (EMCP II) Shutdown Mode - For PEEC and EUI Engines
Electronic Modular Control Panel II (EMCP II) Shutdown Mode - For MUI Engines
Electronic Modular Control Panel II (EMCP II) Alarm Mode
Electronic Modular Control Panel II (EMCP II) AL Fault Codes
3126B Industrial Engines CID 0320 FMI 11 Speed/Timing Sensor mechanical failure
320B, 322B, 325B, 330B and 345B Excavators SmartBoom Operation - If Equipped
3126B Industrial Engines CID 0320 FMI 02 Speed/Timing Sensor Loss of Signal
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Crankshaft Pulley
3054, 3054B and 3056 Marine Engines Installation Guide General Information
C-10, C-12, C-15 and C-16 Industrial Engines PTO Ramp Up/Down Switch Circuit - Test
C-10, C-12, C-15 and C-16 Industrial Engines Air Shutoff System - Test
3126B and 3126E On-highway Engines Ignition Keyswitch Circuit and Battery Supply Circuit - Test
3500B Marine Engines Secondary ECM Assumes Control
Electronic Modular Control Panel II (EMCP II) Fault Log Viewing OP1
G3304 and G3306 Engines Engine Oil Pressure is High
G3304 and G3306 Engines Engine Oil Pressure is Low
G3406 Engine Measuring Engine Oil Pressure
Electronic Modular Control Panel II (EMCP II) Relay Driver Module
Electronic Modular Control Panel II (EMCP II) System Communication Module (Customer)
G3304 and G3306 Engines General Information (Lubrication System)
Electronic Modular Control Panel II (EMCP II) Starting Motor Remains Engaged (for EUI and PEEC Engines)