Rocker Arm and Shaft - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install pushrods (4) into the cylinder head.
Note: Ensure that the pushrods are installed in the original location and that the pushrods are seated in the valve lifters correctly.
Show/hide table
Illustration 1 | g00572218 |
3056 Engine |
- Install a new oil seal in the oil supply passage in the cylinder head.
- Install rocker shaft assembly (3) .
Note: Ensure that the adjustment screws are seated in the ends of pushrods (4) .
Show/hide table
Illustration 2 | g00572217 |
3056 Engine |
- Lubricate nuts (1) and bolt (2) with clean engine oil.
- Alternately tighten the nuts and the bolt. Begin in the center and work toward the outside. Tighten the nuts and bolt on an aluminum bracket to a torque of 40 N·m (30 lb ft). Tighten the nuts and bolt on a cast iron bracket or a steel bracket to a torque of 75 N·m (55 lb ft).
End By: Install the valve mechanism cover. Refer to Disassembly and Assembly, "Valve Mechanism Cover - Remove and Install".
Caterpillar Information System:
3054, 3054B and 3056 Marine Engines Valve Mechanism Cover - Remove and Install - 3056 Engine
3054 and 3056 Marine Generator Set Engines Rocker Arm and Shaft - Remove
G3500 Engines Restriction of Air Inlet and Exhaust
3054, 3054B and 3056 Marine Engines Sea Water Strainer - Clean/Inspect
G3406 Engine Governor - Adjust
3054, 3054B and 3056 Marine Engines Vibration Damper and Pulley - Remove and Install
G3304 and G3306 Engines Testing the Cooling System
G3406 Engine Visual Inspection
C7 and C9 On-Highway Engines Engine Misfires, Runs Rough or Is Unstable
3054 and 3056 Marine Generator Sets Fuel System Primary Filter (Water Separator) Element - Replace
C-10, C-12, C-15 and C-16 Industrial Engines Diagnostic Lamp Circuit - Test
G3304 and G3306 Engines Cylinder Block
3054 and 3056 Marine Generator Set Engines Expansion Tank - Remove and Install
3126B and 3126E On-highway Engines Check Engine Lamp Circuit - Test
C-10, C-12, C-15 and C-16 Industrial Engines Switch Circuits - Test
3054, 3054B and 3056 Marine Engines Reference Material
G3600 Engines Customer Passwords
3114, 3116, and 3126 Engines for Caterpillar Built Machines Inlet and Exhaust Valve Guides - Remove and Install
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Fuel Injection Lines
UPS 250 and UPS 300 Uninterruptible Power Supplies Status Messages
3054, 3054B and 3056 Marine Engines Installation Guide General Information
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Crankshaft Pulley
3126B Industrial Engines CID 0320 FMI 02 Speed/Timing Sensor Loss of Signal
320B, 322B, 325B, 330B and 345B Excavators SmartBoom Operation - If Equipped