Starting the Engine
Refer to the Owner's Manual of the OEM for your type of controls. Use the following procedure in order to start the engine.
- Place the transmission in NEUTRAL.
- Move the throttle to the low idle position.
- Turn the ignition switch to the ON position.
- Press the start button or turn the ignition switch to the START position in order to crank the engine. If the engine fails to start within 15 seconds, release the start button, or the ignition switch. Wait for two minutes in order to allow the starting motor to cool before attempting to start the engine again.
- As soon as the engine starts, release the start button, or the ignition switch.
- Allow the engine to idle for approximately five minutes. Idle the engine until the water temperature gauge has begun to rise. Check all gauges during the warm-up period.
Note: Oil pressures and fuel pressures should be in the normal range on the instrument panel, if equipped. Do not apply a load to the engine or increase engine rpm until the oil pressure gauge indicates at least normal pressure. Inspect the engine for leaks and/or unusual noises.
Show/hide table
NOTICE |
---|
Oil pressure should rise within 15 seconds after the engine starts. Do not increase engine rpm until the oil pressure gauge indicates normal. If oil pressure is not indicated on the gauge within 15 seconds, DO NOT operate the engine. STOP the engine, investigate and correct the cause. |
- Operate the engine at low load until the coolant temperature reaches 60 °C (140 °F). Check the gauges during the warm-up period.
Caterpillar Information System:
G3408 and G3412 Engines Flywheel Housing
3500 Generator Set Engines Coolant Temperature Switch
3054, 3054B and 3056 Marine Engines Gauges and Indicators
G3406 Engines Coolant Temperature Sensor
C-10 and C-12 Industrial Engines Fuel Priming Pump and Primary Fuel Filter
G3406 Engines Power Take-Off Clutch
3114, 3116 and 3126 Engines Air Compressor Drive Gear - Install
G3406 Engines Accessory Drive
G3406 Engines Vibration Damper and Pulley
3054, 3054B and 3056 Marine Engines Engine Description
3524B Engines for 797 and 797B Off-Highway Trucks Valve Lash Check
Uninterruptible Power Supply (UPS) 250 Maintenance Interval Schedule
3054, 3054B and 3056 Marine Engines Cold Weather Starting
3500B and 3500B High Displacement Generator Set Engines Electronic Control System Operation
3500B and 3500B High Displacement Generator Set Engines Fuel Injector
3500B Engines Jacket Water Cooling Circuit
G3406 Engines Timing Advance
3500B and 3500B High Displacement Generator Set Engines Separate Circuit Cooling System
3508B Industrial Engines Crankshaft
3508B Engine for Caterpillar Built Machines Camshaft
3500B and 3500B High Displacement Generator Set Engines Alternator
3500B and 3500B High Displacement Generator Set Engines Starting Solenoid
3500B and 3500B High Displacement Generator Set Engines Starting Motor
3500B and 3500B High Displacement Generator Set Engines Engine Speed Sensor