Pinion Clearance - Adjust
电磁阀在起动马达上的位置控制小齿轮的间隙。 如果电磁阀的位置正确的话,小齿轮间隙也是正确的。 进行下述程序来调整电磁阀位置。
Show/hide table
图 1 | g00301238 |
电磁阀总成 典型实例 (1) 中间壳体 (2) 电磁阀安装托架 (3) 螺栓 (X) 调整距离 |
- 检查中间壳体 (1) 与电磁阀安装托架 (2) 之间的距离 (X) 。 使用卡尺来检查距离 (X) 。
(X) 距离 ... 62.05 ± 0.35 mm (2.443 ± 0.014 in)
- 如果距离 (X) 不正确的话,松开螺栓 (3) ,移动电磁阀直到距离 (X) 正确为止。 电磁阀安装托架 (2) 有长形螺栓孔。
- 正确调整之后,拧紧螺栓 (3) 至拧紧为 12 ± 3 N·m (9 ± 2 lb ft)。
Caterpillar Information System:
3612 and 3616 Engines Fuel Injection Control Linkage
2000/03/06 Service Charts and Decals Available {0374, 0375, 7405, 7557}
3412C Engine Vibration Damper - Check
325D and 329D Excavators Hydraulic System Accumulator (Pilot)
3512 and 3516 EUI Engines for Caterpillar Built Machines General Information (Air/Electric Starting System)
3306C Engines for Caterpillar Built Machines Battery - Test
3126B Engines Electric Starting System - Test
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Event Codes
3412C Engine Piston Ring Groove - Inspect
3408E and 3412E Engines for Caterpillar Built Machines Valve Mechanism Cover
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0828 - FMI 08 Right Exhaust Temperature signal abnormal
3412C Engine Water Temperature Regulator - Test
3612 and 3616 Engines Fuel Injector
3612 and 3616 Engines Fuel Injection Cycle
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Ignore Brake/Clutch Switch Circuit - Test
3612 and 3616 Engines Aftercooler
G3500B Engines Electrohydraulic Oil Pressure - Measure - Adjustment Procedure
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Torque Limit Switch Circuit - Test
3126E Truck Engine Flywheel - Install
3612 and 3616 Engines Fuel System Operation
3612 and 3616 Engines Turbocharger
723PLUS Digital Speed Control Conclusion of Setup Procedures
3126E Truck Engine Pistons and Connecting Rods - Remove
2000/06/01 New Pump Group With Improved Internal Sealing Used In Hydrax System {1289}