Conclusion of Setup Procedures
Save the set points by pressing the "SAVE" key on the programmer or use the Control View or the Watch Window for the control. Review all the set points and record setpoints in this Service Manual, "Programming Checklist" for future reference. The settings can also be saved by using the Control View or the Watch Window for a later download. This function can be very useful for the start-up of another similar unit or useful if the replacement of the control is necessary. Power down the control for about ten seconds. Restore the power and verify that all set points are recorded.
Show/hide table
NOTICE |
---|
To prevent possible damage to the engine resulting from improper control settings, make sure you save the set points before removing power from the control. Failure to save the set points before removing power from the control causes them to return to the previously settings that have been saved. |
If you use the programmer, disconnect the programmer from the control. The Control View or the Watch Window may remain connected or removed from the control at the user's discretion. Close the cover over the J1 port and then tighten the retaining screw if the connection is removed.
Caterpillar Information System:
3612 and 3616 Engines Turbocharger
3612 and 3616 Engines Fuel System Operation
3126E Truck Engine Flywheel - Install
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Torque Limit Switch Circuit - Test
G3500B Engines Electrohydraulic Oil Pressure - Measure - Adjustment Procedure
3612 and 3616 Engines Aftercooler
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Ignore Brake/Clutch Switch Circuit - Test
3612 and 3616 Engines Fuel Injection Cycle
3612 and 3616 Engines Fuel Injector
3408C, 3412C and 3412D High Performance Marine Engines Pinion Clearance - Adjust
3612 and 3616 Engines Fuel Injection Control Linkage
2000/03/06 Service Charts and Decals Available {0374, 0375, 7405, 7557}
3126E Truck Engine Pistons and Connecting Rods - Remove
2000/06/01 New Pump Group With Improved Internal Sealing Used In Hydrax System {1289}
3176C and 3196 Industrial Engines Alternator and Regulator
723PLUS Digital Speed Control Initial Adjustments
3612 and 3616 Engines Centrifugal Oil Filters
3612 and 3616 Engines Engine Oil Coolers and Temperature Regulators
3612 and 3616 Engines Engine Oil Filters
3126B Engines Engine Speed - Check
988G Wheel Loader Electrohydraulic System Electronic Control Module (ECM) - Flash Program
3408E and 3412E Engines for Caterpillar Built Machines Gear Group (Front) - Time
3612 and 3616 Engines Internal Lubrication
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Starting Aid Switch Circuit - Test