Electrohydraulic Oil Pressure - Measure - Adjustment Procedure
Show/hide table
Tools Needed | Quantity |
6V-0852 Dust Cap | 1 |
5E-4852 Relief Valve | 1 |
1U-5481 Pressure Gauge Group
8T-0849 Pressure Gauge 6V-3965 Fitting |
1
1 1 |
1U-5482 Pressure Adapter Group
6V-3990 Coupler 6V-4143 Coupler 6V-4144 Coupler 6V-3965 Fitting |
1
1 1 1 1 |
The 1U-5481 Pressure Gauge Group is used to MEASURE the pressure in the system. The 1U-5482 Pressure Adapter Group is used to ADJUST the pressure in the system.
Show/hide table
Illustration 1 | g00684378 |
(1) Dust cap
(2) Pressure fitting (3) Relief valve |
- Remove dust cap (1) from pressure fitting (2).
- Use the pressure gauge and the proper coupler in order to connect the pressure gauge to pressure fitting (2). Refer to Table 1 for the correct coupler.
Show/hide table
Illustration 2 g00684377 (3) Relief valve
(4) Adjusting bolt
(5) Locknut - Loosen locknut (5).
- Start the engine and operate the engine at the rated speed.
- Use an allen wrench in order to turn adjusting bolt (4). Set the pressure to
1380 ± 70 kPa (200 ± 10 psi) .Turn the adjusting bolt clockwise in order to increase the pressure. Turn the adjusting bolt counterclockwise in order to decrease the pressure.
- After the pressure is correct, tighten locknut (5).
- Stop the engine.
- Disconnect the pressure gauge from pressure fitting (2). Install dust cap (1).
Caterpillar Information System:
3612 and 3616 Engines Aftercooler
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Ignore Brake/Clutch Switch Circuit - Test
3612 and 3616 Engines Fuel Injection Cycle
3612 and 3616 Engines Fuel Injector
3408C, 3412C and 3412D High Performance Marine Engines Pinion Clearance - Adjust
3612 and 3616 Engines Fuel Injection Control Linkage
2000/03/06 Service Charts and Decals Available {0374, 0375, 7405, 7557}
3412C Engine Vibration Damper - Check
325D and 329D Excavators Hydraulic System Accumulator (Pilot)
3512 and 3516 EUI Engines for Caterpillar Built Machines General Information (Air/Electric Starting System)
3306C Engines for Caterpillar Built Machines Battery - Test
3126B Engines Electric Starting System - Test
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Torque Limit Switch Circuit - Test
3126E Truck Engine Flywheel - Install
3612 and 3616 Engines Fuel System Operation
3612 and 3616 Engines Turbocharger
723PLUS Digital Speed Control Conclusion of Setup Procedures
3126E Truck Engine Pistons and Connecting Rods - Remove
2000/06/01 New Pump Group With Improved Internal Sealing Used In Hydrax System {1289}
3176C and 3196 Industrial Engines Alternator and Regulator
723PLUS Digital Speed Control Initial Adjustments
3612 and 3616 Engines Centrifugal Oil Filters
3612 and 3616 Engines Engine Oil Coolers and Temperature Regulators
3612 and 3616 Engines Engine Oil Filters