Water Temperature Regulator - Test
Show/hide table
Personal injury can result from escaping fluid under pressure. If a pressure indication is shown on the indicator, push the release valve in order to relieve pressure before removing any hose from the radiator. |
- Heat water in a pan until the temperature is 92 °C (198 °F).
- Hang the water temperature regulator in the pan of water. The water temperature regulator must be below the surface of the water and away from the sides and the bottom of the pan.
- Keep the water at the correct temperature for ten minutes.
- After ten minutes, remove the water temperature regulator. Immediately check the distance that the water temperature regulator has opened.
If the distance is less than the distance specified in the manual, replace the water temperature regulator. Refer to Specifications, "Water Temperature Regulator".
Caterpillar Information System:
3306C Engines for Caterpillar Built Machines Charging System - Test
3512B Engine for SPF343, SPS343, and SPT343 Pumpers MID 036 - CID 0336 - FMI 02 Incorrect ECS Switch inputs
3126B Engines Pinion Clearance - Adjust
3512B Petroleum Engines with the ADEM 2 Electronic Control Module MID 036 - CID 0342 - FMI 07 Secondary Speed Sensor misinstalled
3512B Petroleum Engines with the ADEM 2 Electronic Control Module MID 036 - CID 0190 - FMI 07 Primary Speed Sensor misinstalled
3408E and 3412E Engines for Caterpillar Built Machines Cooling System - Test
325D and 329D Excavators Hydraulic System Check Valve (Load)
3126B Engines Piston Ring Groove - Inspect
320D Excavator Cab Visor - If Equipped
325D and 329D Excavators Roof Hatch
2000/03/13 Use 152-1057 Fuel Injector Installer For Engine Bore Insertion {0706, 1290}
Replacing Bonded Windows {7310} Replacing Bonded Windows {7310}
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0828 - FMI 08 Right Exhaust Temperature signal abnormal
3408E and 3412E Engines for Caterpillar Built Machines Valve Mechanism Cover
3412C Engine Piston Ring Groove - Inspect
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Event Codes
3126B Engines Electric Starting System - Test
3306C Engines for Caterpillar Built Machines Battery - Test
3512 and 3516 EUI Engines for Caterpillar Built Machines General Information (Air/Electric Starting System)
325D and 329D Excavators Hydraulic System Accumulator (Pilot)
3412C Engine Vibration Damper - Check
2000/03/06 Service Charts and Decals Available {0374, 0375, 7405, 7557}
3612 and 3616 Engines Fuel Injection Control Linkage
3408C, 3412C and 3412D High Performance Marine Engines Pinion Clearance - Adjust