Engine Support (Front) - Remove and Install
Removal Procedure
Start By:
- Remove the crankshaft vibration damper and the pulley.
- Attach a suitable lifting device to the engine front support (1). The weight of the engine front support is approximately 27 kg (60 lb).
Show/hide table
 | |
| Illustration 1 | g00678266 |
- Remove eight bolts and washers (2) .
- Remove the engine front support (1) .
Installation Procedure
- Attach a suitable lifting device to the engine front support (1). The weight of the engine front support is approximately 27 kg (60 lb).
Show/hide table
| | |
| Illustration 2 | g00678266 |
- Lift the engine front support (1) into position.
- Install eight bolts and washers (2). Tighten the bolts (2) to a torque of 105 ± 20 N·m (77 ± 15 lb ft).
End By: Install the crankshaft vibration damper and pulley.
Caterpillar Information System:
G3304 and G3306 Engines Test Tools for the Cooling System
2000/02/01 New Method To Determine When To Clean The Aftercooler Core {1064}
3176C and 3196 Marine Engines Water Outlet Manifold - Install
2000/02/01 Revised Oil Level Gauge Calibration Chart for 3412E Marine Engines {1326}
3512B Petroleum Engines with the ADEM 2 Electronic Control Module Engine Cranks but Will Not Start
3126B Engines Finding Top Center Position for No. 1 Piston
3176C and 3196 Marine Engines Water Outlet Manifold - Remove
3176C and 3196 Marine Engines Turbocharger Outlet Pressure Sensor - Remove and Install
3508B Industrial Engines Turbocharger
3176C and 3196 Marine Engines Heat Exchanger - Install
2000/02/01 Solenoid Available To Service Hydrax Actuators {1259}
3114, 3116, and 3126 Engines for Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
3176C and 3196 Marine Engines Coolant Level Sensor - Remove and Install
2000/07/01 High Efficiency Orifice (HEO) Fuel Injectors Are Now Used For Service Repairs {1290}
3176C and 3196 Marine Engines Inlet Air Temperature Sensor - Remove and Install
3408E and 3412E Engines for Caterpillar Built Machines Air Inlet and Exhaust System
3512B Engine for SPF343, SPS343, and SPT343 Pumpers Diagnostic Codes
3176C and 3196 Marine Engines Service Meter - Remove and Install
3114, 3116, and 3126 Engines for Caterpillar Built Machines Fuel Priming Pump and Primary Fuel Filter - Remove and Install
3176C and 3196 Marine Engines Manifold Adapter - Remove and Install - Right Hand Engine Application
3508B Industrial Engines Output for the General System Alarm
3508B Industrial Engines Start Enable Output
3508B Industrial Engines Shutdown Notification Output
3114, 3116, and 3126 Engines for Caterpillar Built Machines Engine Oil Pressure Sensor - Remove and Install