Turbocharger Outlet Pressure Sensor - Remove and Install
Removal Procedure
- Remove the bolt from the clip and disconnect the connector (2) .
Show/hide table
Illustration 1 | g00677862 |
- Remove the sensor (1) .
Installation Procedure
- Check the condition of the O-ring seal on the end of the sensor. Replace the O-ring seal, if necessary.
- Install the sensor (1) .
- Reconnect the electrical connector (2) .
- Install the bolt into the clip.
Caterpillar Information System:
3508B Industrial Engines Turbocharger
3176C and 3196 Marine Engines Heat Exchanger - Install
2000/02/01 Solenoid Available To Service Hydrax Actuators {1259}
3114, 3116, and 3126 Engines for Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
3176C and 3196 Marine Engines Heat Exchanger - Remove
3512B Petroleum Engines with the ADEM 2 Electronic Control Module Can Not Reach Top Engine RPM
3516B Engine for Caterpillar Built Machines Symptoms
3500B Engines Engine Monitoring System
3176C and 3196 Marine Engines Exhaust Manifold - Remove and Install
3500B and 3500B High Displacement Generator Set Engines Cat Data Link
3176C and 3196 Marine Engines Air Cleaner - Remove and Install
3512B and 3512C Engines For Caterpillar Built Machines Load Feedback Capability
3176C and 3196 Marine Engines Water Outlet Manifold - Remove
3126B Engines Finding Top Center Position for No. 1 Piston
3512B Petroleum Engines with the ADEM 2 Electronic Control Module Engine Cranks but Will Not Start
2000/02/01 Revised Oil Level Gauge Calibration Chart for 3412E Marine Engines {1326}
3176C and 3196 Marine Engines Water Outlet Manifold - Install
2000/02/01 New Method To Determine When To Clean The Aftercooler Core {1064}
G3304 and G3306 Engines Test Tools for the Cooling System
3176C and 3196 Marine Engines Engine Support (Front) - Remove and Install
3176C and 3196 Marine Engines Coolant Level Sensor - Remove and Install
2000/07/01 High Efficiency Orifice (HEO) Fuel Injectors Are Now Used For Service Repairs {1290}
3176C and 3196 Marine Engines Inlet Air Temperature Sensor - Remove and Install
3408E and 3412E Engines for Caterpillar Built Machines Air Inlet and Exhaust System