Housing (Front) - Remove
Removal Procedure
Start By:
- Remove the crankshaft front seal. Refer to Disassembly and Assembly, "Crankshaft Front Seal - Remove".
- Remove the camshaft. Refer to Disassembly and Assembly, "Camshaft - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Remove any external components, if equipped.
- Remove bolts (1) that fasten front housing (2) to the cylinder block and to the engine oil pan.
Show/hide table
Illustration 1 | g00748748 |
- Remove front housing (2). Clean the sealant from front housing (2) and the cylinder block.
Caterpillar Information System:
3126B Marine Engine Front Cover - Install
3126B Marine Engine Front Cover - Remove
3126B Engines for Caterpillar Built Machines Camshaft - Install
3126B Marine Engine Vibration Damper and Pulley - Remove and Install
3176C and 3196 Engines for Caterpillar Built Machines Piston Cooling Jet
3126B Marine Engine Unit Injector Hydraulic Pump - Install
3126B Marine Engine Crankshaft - Remove
3126B Marine Engine Unit Injector Hydraulic Pump - Remove
3126B Marine Engine Injection Actuation Pressure Control Valve - Install
3126B Marine Engine Injection Actuation Pressure Control Valve - Remove
3054 and 3056 Industrial and Generator Set Engines General Coolant Information
3126B Marine Engine Crankshaft - Install
3126B Engines for Caterpillar Built Machines Camshaft - Remove
3054 and 3056 Industrial and Generator Set Engines Crankshaft Vibration Damper - Inspect
3114, 3116, and 3126 Engines for Caterpillar Built Machines Water Pump - Disassemble
3126B Marine Engine Housing (Front) - Install
3126B Marine Engine Lifter Group - Remove and Install
3126B Marine Engine Cylinder Head - Remove
3126B Marine Engine Cylinder Head - Install
C-10 and C-12 Industrial Engines Speed/Timing Sensor
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Retarder (Compression Brake) Solenoid Circuit - Test
3054B Industrial Engine Engine Design
3054B Industrial Engine Fuel Injection Pump
3406E Truck Engine Cylinder Head Valves